Pyle PTAU23 User manual

MiniStereoPowerAmplifier
PTAU23
2 x 40 Watt with USB, SD, FM, Wireless BT,
AUX, CD and Mic Inputs
Questions? Issues?
We are here to help!
Phone: [phone]
Email: suppor[email protected]

www.PyleUSA.com
2
www.PyleUSA.com
3
IMPORTANT SAFETY INSTRUCTIONS
1. Read Instructions - All the safety and operating instructions should be read
before operating the appliance.
2. Retain Instructions - The safety and operating instructions should be retained
for future reference.
3. Head Warnings - All warnings on the appliance and in the operating
instructions should be adhered to.
4. Follow Instructions
5. Water and Moistunt - The appliance should not be used near water for
example, near a bathtub, washbowl, kitchen sink, laundry tub, swimming pool,
or a wet basement.
6. Ventilation - The appliance should be situated so that its location or position
does not interfere with its proper ventilation. For example, the appliance
should not be situated on a bed, sofa, rug, or similar surface that may block
the ventilation openings or placed in a built-in installation, such as a bookcase
or cabinet that may impede the ow of air through the ventilation openings.
7. Heat - The appliance should be situated away from heat sources such as
radiators, heat registers, stoves, or other appliances including ampliers that
produce heat.
8. Power Sources - The unit should be connected to a power supply only of the
type described in the operating instructions or as marked on the appliance.
9. Grounding or Polarization - Precaution should be taken to insure that the
grounding or polarization means of an appliance is not defeated.
10. Power-Cord Protection - Power supply cords should be routed so that they
are not likely to be walked on or pinched by items placed upon or against
them, paying particular attention to cords at plugs, convenience receptacles,
and the point at which they exit from the appliance.
11. Cleaning - The appliance should be cleaned only as recommended by the
manufacturer.
12. Power Lines - An outside antenna system should not be located in the
vicinity of overhead power lines or other electric light or power circuits or
where it can fail into such power lines or circuits. When installing an outside
antenna system, extreme care should be taken to keep from touching such
power lines or circuits as contact with them might be fatal.
13. Non-Use Periods - The power cord of the appliance should be unplugged
from the outlet when the appliance is to be left unused for a long period of
time.
14. Obiect and Uquid Entry - Care should be taken so that objects do not fall
and liquids are not spilled into the enclosure through openings.
15. Carts and Stands - If the appliance is used with a cart or stand,
the cart or stand should be a type recommended by the
manufacturer. An appliance and cart combination should be
moved with care. Quick stops, excessive force, and uneven surfaces cause
the appliance and cart combination to overturn.
16. Mounting - The appliance should be mounted only as recommended by the
manufacturer.
17. Damage Requiring Service - The appliance should be serviced by qualied
service personnel when:
A. The power-supply cord or plug has been damaged.
B. Objects have failen into, or liquid has been spilled into the appliance
enclosure.
C. The appliance has been exposed to rain.
D. The appliance has been dropped, or the enclosure has been damaged.
E. The appliance does not appear to operate normally or axtiibits a marked
change in performance.
18. Servicing - The user should not attempt to service the appliance beyond
that deecribed in the user's operating instructions. All other servicing should
be referred to qualied personnel.
19. Overloading - Do not overload wall outlets and extension cords as this can
result in a risk of re or electric shock.
20. Replacement Parts - When replacement parts are required, be sure the
service technician has used replacement parts specied by the manufacturer
or have the same characteristics as the original part.
Unauthorized substitutions may result in re,elecb1c shock or other hazards.
21. Safety Check - Upon completion of any service or repairs to this appliance,
ask the service technician to perform safety checks to determine that the
appliance is in proper operating condition.

www.PyleUSA.com
4
www.PyleUSA.com
5
Your new PTAU23 Mini Stereo Power Amplier
gives you the power and versatility you need in a professional sound system.
Its wide frequency response make it suitable for amplifying music or vocal
program material. The front located USB 2.0 interface allows you to connect the
input of your MP3 devices conveniently, and the MIC PAGER/MIXING function
oers the exibility of using it at paging or musical events. It can be used for
meeting halls, house, restaurant, school, stores, live bands, or oce.
FEATURES AND CONTROLS
1. Power ON/OFF: Main power switch
2. Power ON/OFF LED Indicator: The indicator lights up when the amplier is
turned ON.
3. USB 2.0 Input Interface with LED Indicator: Press to play the last
song backward, press to play the next song forward, and press
to play and/or pause the song. When the song is ceased from playing, it will
be memorized to resume once the amplier is reactivated and/or the USB
input is selected again.
4. 1/8" AUX/CD IN: Connect the MP3 Device (player) sources such as PC (CD ROM),
laptop, walkman, iPod and mobile phones
5. 1/4" PHONE Jack: Accepts headphones with 1/4" plug.
6. MIC Volume Control: Lets you adjust the volume of connected MIC to the
proper setting
7. MASTER Volume Control: Lets you control the overall volume level.
It doesn't aect the volume of MIC.
8. BALANCE Control: Lets you adjust the sound balance between the left and
right of amplier outputs
9. BASS and TREBLE Control: Allows you to boost or attenuate bass and treble
for the desired sound
10. AUX 1/AUX 2/CD/USB Input Selector: Lets you select the desired input
music source. When it is switched to AUX1, AUX2, or CD input while the
USB is still on playing, the playing signal of USB continues, just it is not sent
to the amplier's output
11. LED Display: Displays the output level and selected input
12. SD Card Input
13. USB Flash Drive Input
14. Wireless BT Antenna: Wireless BT Streaming receiver
15. FM ANTENNA CONNECTOR: Connect for AM and FM antennas
16. AUX 1/AUX 2/CD RCA Inputs: Lets you connect most high level audio
sources such as CD player, tape deck, tuner, camcorder, or VCR
17. REC RCA Output: Lets you connect the amplier to a tape deck for recording
18. Push Type Speaker Terminal: Lets you easily connect speaker wires directly
to the amplier. The speaker impedance can be ranged from 4 to 8 Ohms for
the general stereo output. The total speaker impedance must be at least
4-Ohm per channel at stereo mode.
2 3 11 12 13
1 4 5 6 7 8 9 10
14 15 16 17 18 19
20 21 22 23

www.PyleUSA.com
6
www.PyleUSA.com
7
19. 110/220 Voltage Selector: This amplier has selectable input voltage from
110V/60Hz (the standard in USA and CANADA) to 220V/50Hz (for EUROPEAN
operation). Please make sure the switch is in the proper position before
operating, otherwise, the severe damage will be incurred and not covered
by the warranty.
20. 1/4" MIC Input Jack: Lets you connect a microphone with a 1/4" plug.
21. Switchable MIC PAGER and MIXING Modes: Set to PAGER, the signal from
AUX 1/AUX 2/CD will be attenuated BY -12dB and the signal from MIC will
override to page (Auto Talkover), it is good for paging system. Set to MIXING,
the signals from AUX 1/AUX 2/CD and MIC will be existed at the same time,
it acts like playing at KARAOKE event.
22. Replaceable Power Fuse: The amplier uses a fuse for protection against
surges and short circuit. If the amplier suddenly turns o and will not turn
on, check the fuse and if necessary replace it with a 1 amp, 250-volt, fast-
acting, 5x20mm fuse (not supplied).
23. AC IN Power Cord
Care and Maintenance
Your Pyle Pro Amplier is an example of superior design and craftsmanship.
The following suggestions will help you care for your amplier so you can
enjoy years of use:
• Keep the amplier dry. If it gets wet, wipe immediately.
• Use the amplier only in well-ventilated installations.
• Handle the amplier gently and carefully - do not drop!
• Keep the amplier away from dust adn dirt.
• Wipe occasionally with a damp cloth to keep it looking new.
• Do not use harsh chemicals, solvents or detergents!
CONNECTION DIAGRAM

www.PyleUSA.com
8
www.PyleUSA.com
9
WIRELESS BT STREAMING OPERATION INSTRUCTION
External devices which have a built-in BT feature can be connected to this
amplier wirelessly to play through the amplier's speakers. If your amp is
connected to speakers, you will hear audible tones which will help for
connecting.
1. At rst be sure that the amplier is powered ON, and turn the volume to
low. Pull out the BT Antenna at the back panel for better receiving signal.
Press MODE button on the front panel then the BT Indicator light will be lit.
(The unit is automatically ready to pair with your device)
2. Turn ON the Wireless BT function of your external device.
3. Search for available devices within range of your external Wireless BT device.
4. Wait for a while then nd the “PYLEUSA” on the paired devices list on your
external device and select “PYLEUSA”, or nd the “BT” on the paired devices
list on your external device and select “BT”.
5. Your amplier will beep and the lights will ash once when pairing is
successful.
6. You can now play music and other audio on your external device through
your amplier.
7. The amplier will beep and the lights will ash once again when the
external device is turned o or unpaired.
Wireless BT Connectivity:
• Built-in Wireless BT Audio Receiver
• Simple Pairing for Wireless Music Streaming
• Works with All of Today’s Latest Wireless BT Devices
(Smartphones, Tablets, Laptops, Computers, etc.)
• Wireless BT Version: 5.0
• Wireless BT Network Name: ‘PYLEUSA’
• Wireless Range: Up to 40’+ ft.
Features:
• RCA REC Output
• 1/4" Phone Jack
• 1/4" MIC Input Jack
• USB Flash & SD Memory Card Readers
• Digital LED Display for Playing information
• Built-in Wireless BT for Audio Streaming
• MP3 Digital Audio File Playback Compatible
• AUX1, AUX2, CD & RCA Inputs
• Four Push Type Speaker L/R Terminals
• Switchable MIC Pager and Mixing Modes
• Switchable AUX1, AUX2, CD, USB Inputs
• Bass, Treble, Balance, Master & Mic Volume Controls
What's in the Box:
• Mini Stereo Power Amplier
• Remote Control
• FM Antenna
Technical Specs:
• Power Output: 2 x 40 Watt Peak
• RMS Power Output: 8 Watt x 2 @ 8Ohm
• Power Supply: 120V /240V
• Construction Material: Iron
• Remote Control Battery: (1) x CR-2025 (included)
• Impedance: 4-8Ohm
• Frequency Response:20Hz-20KHz
• Dimensions (L x W x H): 5.39'' x 7.48'' x 2.72'' -inches
This product can expose you to a chemical or group of checmicals, which may include
“Nickel Carbonate” which is known in the state of California to cause cancer, birth defects,
or other reproductive harm. For more info, go to https://www.p65warnings.ca.gov/.