Quicklynks TURBOGAUGE V HUD Instruction sheet

1
How to in stall the HUD.
1. Stick Velcro strip to the center of product back.
2.Stick the products with velcro strip to the holder, post the holder toward auto front glass, confirm the reflecting
position once connect to the power from the automobile.
3. Clean the reflecting position of front glass by duster cloth, in order to stick reflecting sheet.
Reflecting Sheet sticking position guide:
Tip: Do not stick the reflecting sheet in front of the driver's sight, it will affect the driving behavior,
The best position is to the bottom in front of auto glass, or the middle or bottom of the both sides, not affect the driver
sight. Best position as below
4.Tear the protective layer of the reflecting sheet, spray some water to the tearing face of sheet in order to easy to
move during the sticking. Then stick the sheet to the reflecting location (note: the inside of the front glass).
5.After adjusting the sheet to the appropriate location, using a flat card to scrape the inside water until there are no
bubbles or water inside.

2
6..wait a few minutes, get rid of the water sheet, gently wipe the droplets around.
7..Stick Velcro strip onto the dashboard to be fasten to the holder, adjust the holder slightly to reach the best
reflecting effect.
Tips: head-up display is convenient, but be sure not to stare at numbers, while ignoring traffic safety!
Holder
The hold can rotate vertically 90 degree, and horizontally 360 degree.
HUD mode:
The tool with holder face to front glass from -5 degree to 5 degree vertocally, it depends on the different inclination of
front glass
Trip monitor mode:
In direct sunlight conditions, or the reflecting effect is not good, you can use trip monitor normal display mode, just
turn the holder to 90degree, then you can see the display face to face.
Item selection
When press the down button in the menu, the upper-right corner will show the position for item as below
The black frame means that it can be changed.
The according item will flash until 3 seconds to confirm.
Press down button, it will turn to next position to choose
The other item.