R-Go Riser Duo User manual

Insert the support in the slot of your desired
height Lift the top plate of the stand (1)
Lower the top plate and make sure that both
laptop supports go into the laptop slot
Turn both laptop
supports (2). Make sure that both laptop
supports are right angles to the top plate
The top plate rest on the middle plate and
the laptop supports are in the laptop slot. The
laptop stand is now ready to use
Laptop Stand Instruction Steps
7 8
9 10
11 12

The bottom side of a stand Flip over the document holder
Flip over the whole stand
Open the stand en put in desired slot of your
height
Flip over until parallel with the stand
Grab top and middle plate of stand and leave
bottom on the table
Laptop Stand Instruction Steps
1 2
3 4
5 6

The top plate (3) is right-angled with the
middle plate (4).
And turn both tablet
support at the same time (use both hands).
Make sure you turn the tablet support until
the hook is in front of the tablet slot
Move the tablet hook into
the slot (1) and then move the hook around
the middle plate (2) until the hook is
right-angled with the middle plate
Make sure that the hooks of the tablet sup-
ports go into the tablet slots, while (1) lifting
the top plate until it is vertical.
Make sure that the tablet support is hooked
around the middle plate. Your Tablet stand is
ready for use
3
1
2
1
4
Tablet Stand Instruction Steps
1
2
2
8 9
10 11
12 13

The bottom side of a stand
Flip over the document holder
until parallel with the stand
Flip over the whole stand
Tablet Stand Instruction Steps
Insert the support in the slot of your desired
height
Lift the top plate of the stand (1)
Open the stand en put in desired slot of your
height
Grab top and middle plate of the stand and
leave the bottom on the table
1 2 3
4 5
6 7