Rapidmesh Rmwsl0227 User manual

1300 911 914 | sales@rapidmesh.com.au | www.rapidmesh.com.au

RMWSL0227 Above Bonnet Storage

Assembly Instructions

Additional Tools Required;

Hardware included;

10 x 50mm Hex Head Screws

23 x 60mm Hex Head Screws

2 x 70mm Hex Head Screws

17 x 80mm Hex Head Screws

Components included;

Roof x 2

Floor x 2

Front Panel x 2

Door x 2

Back Panel x 2

Side Panel x 2

Corner Legs x 4

Centre Leg x 1

Cantilever Support x 1

Joining Bracket x 1

47 x Nut

5 x Flanges

1300 911 914 | [email protected].au | www.rapidmesh.com.au

Step 1.

Unpack the unit and confirm

you have all the parts listed.

Assembly

Entire set up is to be done on level ground.

Requires 2-person assembly.

Step 2.

Loosely fix all Floor, Side, Back, Door

and Roof Panels using the screws and

nuts provided.

Step 3.

Fix all Legs, Cantilever Support and Joining Bracket

to the unit using the screws and nuts provided.

Step 5.

Use bolts provided to fix the legs into the flanges.

Move in to position and fix the flanges to the floor

(hardware not included).

For stability fix unit to a wall (hardware not included).

Step 4.

Tighten all screws.

Our goods come with guarantees that cannot be excluded under the Australian consumer law. You are entitled to a replacement or refund for a major

failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods

fail to be of acceptable quality and the failure does not amount to a major failure. This warranty excludes damage resulting from product misuse or product