Realtree RTK200 User manual

Model RTK200
Assembly Instructions






 
 s  tsus 
REV052720

1
REMOVAL FROM CRATE
1. Remove the metal crate
from the Go-Kart.
2. Locate and Remove
Owner’s/Operator’s manual,
set up instructions and all
documentation.
Note: Read Owner’s /
Operator’s manual
thoroughly before starting
Go-Kart for the first time.
3. Locate and remove all
parts and hardware from
crate and set aside.
Note: Some hardware may
already be mounted on the
Go-Kart. This will have to be
removed and then re-
attached during assembly.
St eering Wheel
S t ee r i n g W h ee l
S teer ing W heel C ap
Wheel Parts
Rear Tires
Front Tires
Rubber Hub Caps
Rear Rack

2
Brush Guard Parts
Brush Guard Side Support
Main Brush Guard
Brush Guard Cross Braces
Safety Net
Safety Belt
Seat

3
Hardware:
REAR WHEEL ASSEMBLY
12
M20 Washer 2ea. (1)
4
M20 Castle nuts 2ea. (2)
3
Cotter pins 2ea. (3)
M20 Large
Washer
2ea. (4)
1.Lift the Kart with a jack.
Note: Make sure tire tread faces forward
and Air valve stem is on the outside of the
tire when installing.
3.Install Hub Caps (5) by snapping on hub.
4
1
2
3
Failing t o install co tt er pins
could
be hazardous.
Failing
t o install co tt er pins
could cause
the castle nuts
t o fall off resulting in an
accident.
Nev er operat e Go Kar t
without co tt er pins installed .
5
2. Install rear tire assembly in the
following order:
1. Wheel
2. M20 Large washer (4)
3. M20 Washer (1)
4. M20 Castle nut (2)
5. Colter pin (3)
!W
ARNING
Make sure
the trend
faces
forward

4
FRONT WHEEL ASSEMBLY
12
4
Hardware:
M14 Washer 2ea. (1)
M14 Castle nuts 2ea. (2) 3
Cotter pins 2ea. (3)
M14 Large
Washer
2ea. (4)
1. Lift the Kart with a jack.
Make sure
tread faces
forward
3. Install Hub Caps (5) by snapping on hub.
1.
2. Install the front wheel assembly in the
following order.
2.
Wheel
3.
M14 Large washer (1)
4.
M14 Washer (4)
5.
M14 Castle nut (2)
Colter pin (3)
Failing t o install co tt er pins
could be hazardous. Failing
t o install co tt er pins could
cause the castle nuts t o fall
off resulting in an accident.
Nev er operat e Go Kar t
without co tt er pins installed .
123
!W
ARNING
4
5