Remo+ ROTOTOM User manual

ROTOTOM ASSEMBLY INSTRUCTIONS
Turn the long carriage bolt clockwise unl it makes contact with the boom insert.
Place stand and lter in
the upright posion.
Slide the short carriage bolt into the Rototrac approximately to the midway point. Tighten the AD10 adaptor plate to the
Rototrac using the washer, nut, and included wrench. Place Rototrac assembly on top of the Ratchet Block Tilter.
Tension Rod
Ratchet Block Tilter
Rototrac
AD10 Adaptor Plate
Short Carriage
Bolt Notch

Tighten AD10 & Rototrac to the Ratchet Block
with the included Dum Key.
Slide the 10” Rototom Assembly into the
Rototrac with the washer on top.
Tighten the Handle to secure the
10” Rototom to the Rototrac. Re-
peat for the 6” & 8” Rototoms,
sliding them into the Rototrac from
the le side of the stand.
Rotate the enre Rototom assembly
Clockwise to increase the pitch.
Rotate the enre Rototom assembly
Counter Clockwise to decrease the pitch.
6” Rototom 8” Rototom 10” Rototom
Tension Rods should be threaded all the way through and even on
the boom casng
For more informaon visit: remo.com