Renogy MTS-WM User manual

1
MTS-WM
RENOGY Wall Mount System
2775 E Philadelphia St, Ontario, CA 91761
1-800-330-8678

2
Important Safety Instructions
Please save these instructions.
This manual contains important safety, installation, and operating instructions for the Renogy Wall
Mount System. The following symbols are used throughout the manual to indicate potentially
dangerous conditions or important safety information.
WARNING: Indicates a potentially dangerous condition. Use extreme caution when
performing this task.
CAUTION: Indicates a critical procedure for safe and proper operation of the system.
NOTE: Indicates a procedure or function that is important to the safe and proper operation
of the system.
General Safety Information
•Read all of the instructions and cautions in the manual before beginning the installation.
•Do NOT attach solar panel to pole mount until mount is securely fit, and pole base has
been secured.
•Chance to strip nuts and bolts exists.
•Multiple people for installation is suggested.
•Do NOT substitute parts from other manufacture ring sources, doing so may void the
warranty and/or result in an unstable system
•This system is NOT possessing any compliance with residential structural codes and
should not be used in place of a system that is, if so required by local regulations
Installer Responsibilities
•Installation compliance with any applicable codes which are in force at the installation site
•Installation compliance and compatibility with all system components and the environment
including but not limited to roofing, system components, etc.
•Verification that all project information is accurate
WARNING: This equipment should be installed, adjusted, and serviced by qualified electrical
maintenance personnel familiar with the construction and operation of the equipment and the
hazards involved. Failure to observe this precaution may result in bodily injury. Protective gloves
and safety glasses should be worn during installation.

3
Table of Contents
General Information.........................................................................................................................................4
Identification of Parts.....................................................................................................................................5
Installation.............................................................................................................................................................7
Attach the Fixed Bracket and Tilt Arm................................................................................................8
Attach the Panel to the Wall Mount................................................................................................... 10
Install the Wall Mount on Wall............................................................................................................ 11
Install the Wall Mount on Pole ............................................................................................................ 13
Wall Mount Dimensions............................................................................................................................. 14
Compatibility..................................................................................................................................................... 15

4
General Information
The Renogy Wall Mount System is designed for off-grid applications, when mounting on a roof is
not applicable. It supports Renogy solar panels up to 50W. The system comes complete with all
fasteners to secure the system to the installation surface. This system makes the installation of
small solar systems easy, affordable and quick.
Key Features
•5052-H32 aluminum construction
•Stainless steel fasteners
•High-tensile strength
•Corrosion Free
•Attractive brushed aluminum finish
•Precision hole positioning and alignment
•Easy, rapid assembly
•Well-illustrated instructions

5
Identification of Parts
Image
Component
Quantity
Tilt Arm (A)
1
Fixed Bracket (B)
1
M8 T-Bolt (C)
8
M8 Washer (D)
12
M8 Spring Washer
(E)
8

6
End Clamp (F1)
2
End Clamp (F2)
2
M8 Nut (G)
8
Hose Clamp (H1)
2.6 to 3.5 in.
2

7
Hose Clamp (H2)
3.3 to 4.3 in.
2
Hose Clamp (H3)
4.1 to 5.0 in.
2
Expansion Bolt (I)
2
Table 1
Installation
Recommended tools to have before installation (Not provided):
•Socket wrench
•Torque extension
•Box-Leveler
•Tape Measure
•18mm wrench or socket for larger hex nut
•13mm wrench or socket for smaller hex nut
The above tools and equipment are highly recommended to have available to assist with
installation but are in no way a comprehensive list of tools that can ease installation. Installers
feel free to substitute comparable equipment where appropriate.

8
Attach the Fixed Bracket and Tilt Arm
Figure 1
Figure 2
(A)
(B)

9
Figure 3
Note: M8 Washer (D) and M8 Spring Washer (E) are essential parts when tightening M8
Nut (G), over tightening may damage parts
Note: Adjust tilt arm (A) and fixed bracket (B) to desired angle prior to tightening M8 Nut
(G)
Figure 4
(G)
(E)
(D)
(C)

10
Attach the Panel to the Wall Mount
Figure 5
Figure 6
WARNING! Keep hands clear of pinch points!
(G)
(E)
(D)
(C)

11
Figure 7
NOTE: This is what the clamp should look like when it is fastened to the panel.
Install the Wall Mount on Wall
Figure 8
NOTE: Please check the direction of Fixed Bracket (B) prior to installation.
(I)

12
Figure 9
NOTE: Please use proper tool for this installation. Installation process may require
assistance.
(I)

13
Install the Wall Mount on Pole
Figure 10
NOTE: Please check the direction of Fixed Bracket (B) prior to installation. Choose
appropriate Hose Clamp (H) size for installation.
NOTE: Please use proper tool for this installation. Installation process may require
assistance.
(H)

14
Wall Mount Dimensions
Tilt Arm (A)
Fixed Bracket (B)
NOTE: Dimensions in inches.

15
Compatibility
RENOGY Solar Module
Compatibility*
RNG-10D
COMPATIBLE
RNG-10D-SS
COMPATIBLE
RNG-20D
COMPATIBLE
RNG-30D
COMPATIBLE
RNG-30D-SS
COMPATIBLE
RNG-50D
COMPATIBLE
RNG-50D-SS
COMPATIBLE
RNG-80D-SS
INCOMPATIBLE
RNG-100D
INCOMPATIBLE
RNG-100D-S
INCOMPATIBLE
RNG-100D-SS
INCOMPATIBLE
RNG-100D-SSP
INCOMPATIBLE
RNG-100MB
INCOMPATIBLE
RNG-100D-R
INCOMPATIBLE
RNG-160D-SS
INCOMPATIBLE
RNG-300D
INCOMPATIBLE
RNG-50P
COMPATIBLE
RNG-100P
INCOMPATIBLE
RNG-160P
INCOMPATIBLE
RNG-270P
INCOMPATIBLE
RNG-320P
INCOMPATIBLE
Renogy reserves the right to change the contents of this manual without notice.