RH 5962158 Quick reference guide

ASSEMBLY & OPERATING INSTRUCTIONS CENTER POLE UMBRELLA
This operation may require 2 people
1. Remove all packaging, including inside the umbrella.
2. Place umbrella in base and secure by tightening the fastener (note: base is purchased separately).
3. Gently separate each rib outward from center position approx. 4”-6”. Do not force.
If ribs do not move easily, inspect product.
4. Gently slide main hub up center pole by pulling down the marine rope into the fully open position.
Secure by using security pin. (See FIG A)
5. Secure marine rope in rope hook by coiling excess rope on hook located on main hub.
6. Close umbrella when not in use or during wind conditions that exceed manufacturer’s specications.

ASSEMBLY INSTRUCTIONS ACF PROMOTIONAL BASE
global mission control
2900 NW 35th Street, Miami, FL 33142 USA | 305.634.5116 |inf[email protected]om | www.tuuci.com INSA7005 4.12.17
ACF Base Assembly
Step 1
Remove all packaging.
Step 2 Insert plastic cap on stem.
Step 3 Insert stem in base by aligning stem slot to base inner screw.
Step 4 Secure stem by mounting M12 hex head screw with both washers.
2
align slot to inner screw
plastic cap
fender washer
lock washer
Recommended
19mm socket wrench
not included
stem
M12 hex head screw
4
3