7
Footboard
The footboard is shipped in the reverse
position on the tube. Reposition by
removing knob (A) and clamp (B). Rotate
footboard into correct position, replace
clamp and knob and re-tighten
(see Figure 7a).
Figure 7a
Figure 7b
D
C
Figure 7c. The knee board with knee lateral
blocks and round abduction block. Abduction
blocks can be attached on the mainboard or on
the knee board.
Knee board
To remove the knee board for small
children, loosen knob (C) until the plated
clamp can rotate 90°, freeing the knee
board. If abductors were used on the knee
board attach them to the mainboard.
Lower the mainboard to its lowest position,
and raise the footboard so that the top of
the mainboard reaches the user’s chest.
Knee lateral support blocks
To attach the knee lateral blocks, loosen
knobs (D), slide lateral blocks onto knee
board and re-tighten knobs.
Knee lateral blocks can also be adjusted
vertically using knobs (D).
A
B
Notice: When replacing the knee
board, the wooden clamp block goes
down, and the slot for abductors up
(see Figure 7b).
