1. Connect the machine to the running water system (you can also connect it to a
carafe or a large water can).
2. Connect the drain box with the crystal PVC hose to the drain tube or, in case you
don’t have one, to a carafe or an empty large can.
3. Connect the machine to the wall socket and turn on the switch The water will go
into the boiler until it reaches its level, 3/4 of the indicator tube, automatically.
The red ligth in the switchboard will turn on II ( ), indicating the resistance is
working. You have to wait until the machine heats up, then the manometer will reach
to 1 bar approximately; and in that moment the red light will turn o, which indicates
that it is ready to operate.
This red light will turn on every time the machine needs to recuparate temperature.
If the green light is turned on this doesn´t prevent to operate normally the machine
in all its functions.
4. Once completed all the above mentioned, you can start making coee.
You will have to let the water run with the lter holders in so that it can reach
temperature pressing the group switch.
Load the lter holder with the ground coee, completing its capacity and then press it
with the coee press (which is in the mill). If the grinding is correct, the coee will come
out creamy and will ll the cups in approximately 30 seconds. If not, you will have to
correct the grinding (seegrinder indications).
Note: The electropump manometer will go up 9 bar approximately each time a coee
is made.