
INS HX8E INS HX8E
FINISHED
WALL
NIPPLE
SHOULD
PROTRUDE
3/4" - 1"
RAWPLUGS
WALL PLATE
SET SCREW
TEFLON
WASHERS
Rough-Inplumbingshouldensurethat
the1/2"NPTNipple(notsupplied)
protrudenotlessthan3/4"andnot
morethan1"fromtheFinishedWall.
Drilltwo7/16"holes13/8"eithersideof
theNPTNippleandinsertthetwo
Rawplugssupplied.
AssemblethePlatetothewallas
showninFig. 3withtheSetScrewhole
atthebottom.
Don’tforgetthetwoTeflonwashers,
theseprotecttheplatefromscratching
bytheAcornNuts.
ScrewtheWallMountBodyonthe
Nippleandalignverticallyasshownin
Fig. 5 usinga21MMwrenchonthe
plugprovided.
Securetheassemblybytighteningthe
SetScrewontheundersideoftheWall
PlatewiththeAllenKeyprovidedand
removethePlug.
LoosenthePackingNutonthesupplied
Cartridge-twofullturnsshouldbe
sufficient.InsertthecartridgeintheWall
MountBody.
PlaceoneoftheHandlesonthespline
oftheCartridgeandscrewitintothe
WallMountBodyuntillyoufeel
noticeable resistanceandstop.
1 2
3 4
5 6
SWIVEL
NIPPLE POT
FILLER
ARM
TheCartridgewillbeintheOFF position,
turnitON.
RemovetheHandleandreplaceitclose
tobutonetoothofftheON positionas
showninFig.7.
GentlyforcetheHandle(unscrewthe
cartridge)tothedesiredON alignment.
Thisadjustmentshouldnotbemore
than25°.
TightenthePackingNutusinga17MM
wrench.
LoosentheSetScrewintheTieDown
CapandremovetheCap.Thenremove
thesmall TeflonWasheronly.Leave
thelargerWasherontopoftheSwivel
Nipple.
CarefullyassemblethePotFillerArm
asshowntakingcarenottotearthe‘ ’
RingsontheSwivelNipple.
Nowreplacethesmall TeflonWasher
overtheexposedthreadsthenscrew
ontheTieDownCapandsecureitby
re-tighteningtheSetScrew.
ScrewtheFlangeontotheCartridgeas
farasitwillgo,thenfittheTeflon
SpacerintotheFlangeasshown.Make
suretheCartridgeisintheOFF position
andassembletheHandleaccordingly
andsecurebytighteningtheSetScrew
withtheAllenKeyprovided.
7 8
9 10
11 12
2 3/4"
1 3/8"