Open the cover of the battery
compartment.
2
Attach the external battery pack as
shown in the picture.
•
Then, turn the lock control to secure
firmly in place.
1
Carefully check the correct orienta-
tion of the positive and negative ter-
minals of the batteries.
•
Use two AA/R6 type 1.5 V batteries.
3
Use two AA/R6 alkaline batteries. Manganese
batteries have a shorter battery life.
•
Do not mix old and new batteries.
•
Remove the batteries if they will not be used for a long time.
•
Remove the standard batteries when you use an AC adaptor.
Warning
•
Replace the batteries if the remaining battery power indicator “”flashes.
•
Even though the remaining battery power indicator “”may be flashing, if the
batteries have already expired, the LCD remote control will not be lit.
•
Should “”flash, the player will automatically turn off the CD ESP ON mode to
conserve battery power consumption.
•
Standard batteries cannot be recharged.
•
The external battery pack cannot charge, as it does not have the capacity to charge.
Using standard batteries (not supplied)
Put the CD player on a horizontal, vibration-
free and stable surface. Make sure it is a safe
place, where the player is not a danger or an
obstacle to the driver and passengers.
Only use the supplied SCJ-1 DC car adaptor (4.5 V, DC) and
the STA-1 car cassette adaptor. Any other product
may damage the unit.
1
Connect the DC plug of the DC
car adaptor
to the 4.5V DC IN of the
CD player (for a 12V car battery only, negative grounding).
2
In-car use
Time for Bat-
tery Replace-
ment
Rechargeable Rechargeable Batteries +
Batteries Battery Pack (type AA/R6)
MP3-CD 9 hours 20 hours
CD(when ESP is off) 8 hours 16 hours
CD(when ESP is on) 6 hours 14 hours
30 minutes
Battery Life (Using alkaline batteries)
Preparation before using your unit
Insert the DC
car adaptor
into the cigarette lighter socket. If necessary,
clean the cigarette lighter socket to obtain good electrical contact.
3
Turn down the volume and connect the
car
cassette adaptor plug to
the LINE OUT of the CD player.
4
Carefully insert the
car
cassette adaptor into the car radio’s cassette
compartment.
5
Start the CD player and adjust the sound with the car radio controls.
6
SCJ-1
4.5V DC IN
STA-1
•You cannot use this car cassette adaptor with some car cassette deck.
•
Do not expose to strong sunlight or very high temperatures.
•If your car radio has a LINE IN socket, use the LINE IN socket for the car radio
connection instead of the cassette adaptor. Connect the signal lead to this LINE
IN socket and the LINE OUT socket of the CD player.
•Make sure the cord does not hinder your driving.
•Always remove the DC
car
adaptor
from the cigarette lighter socket when the
CD player is not in use.
Note