
Screw list
Prior to assembly, read the instructions carefully. Check all parts against the
parts list. Carry out assembly on a soft surface to avoid scratching .
Please retain this information for future reference. For ease of assembly only
loosely tighten bolts and then tighten fully when assembly is complete.
Page 3 of 4
Assembly Instruction
A(3x)
M5*12 Bolt
B(4x)
M5*40 Bolt
C(14x)
M8*20 Bolt
D(32x)
M8 Flat washer
I(4x)
M6*16 Bolt
F(8x)
M8*35 Bolt
E(24x)
M8 Nut
G(2x)
M12 Nut
H(4x)
M12Washer
STEP 1 - Attach 1 x trolley section (9) and (11) which with axle hole to 1 x long
bracket(7) and 2 x short bracket (8) using 7 x M8 bolts (C) , 7 x M8
washers (D) and 7 x M8 nuts (E). And remember to reserve left handle
holes to connect with handle.
Note - The handle cannot be fixed here until the base was well assembled.
STEP 2 - Attach 1 x long bracket (7) and 1 x trolley section (6) and (10) which
with axle hole to STEP 1 half-completed base using 7 x M8 bolts (C),
7 x M8 washers (D) and 7 x M8 nuts (E).
STEP 4 - Attach1 x bottom shelf (12) to 1 x bottom frame (13), then attach them
to well assembled trolley by 1 x M8 bolts (F) , 2 x M8 washers (D) and
1 x M8 nuts (E) for each side of legs. Note - 8 x M8 bolts (F), 16 x M8
washers (D) and 8 x M8 bolts (D) in total. Enlarged view (16) for your
reference.
STEP 5 - Feed wheel axle (14) through holes in wheel trolley section(10 and 11)
,feed 2 x M12 washers (H) and attach wheels (15) securing with
1 x M12 nut (G) per wheel. Enlarged view (17) for your reference.
STEP 6 - Attach chimney cap (1) to chimney (2) by 3 x M5 bolts (A).
Place chimney (2) to oven body (3) using 4 x M5 bolts (B).
STEP 7 - Attach oven body (3) to well assembled trolley and securing
by 4 x M6 bolts (I).
STEP 3 - Fixed 1 x handle (5) to well assembled trolley by preassembled bolts
and securing by 2 x M8 washer (D) and 2 x M8 nuts (E).