Sensaphonics ASI Audio 3DME User manual

3DME Custom Tour IEM System
Thank you for choosing the 3DME Custom
Tour IEM System. This Active Ambient™ in-
ear monitor system is functionally identical
to the 3DME Music Enhancement system by
ASI Audio, with the addition of 3D custom-fit
soft silicone in-ear monitors (IEMs) from
Sensaphonics.
This addendum to the 3DME Owner’s
Manual addresses only the 3D Custom
Tour earphones. Please refer to the 3DME
Owner’s Manual for full instructions on
system set-up and use. The manual is
available for download at both
www.ASIaudio.com
and
www.Sensaphonics.com.

Inspect the earpieces. The one with the blue dot fits the left ear, red
dot for the right ear. (1,2) Insert the canal portion (sound ports) into the
indicated ear with the cable facing forward. (3) Push the IEM into your
ear canal, rotating as you do, until the earpiece is all the way in, creating
a full seal. It may be helpful to pull back on your ear with the other hand
while pushing the earpiece in.
Note: The earpiece cables are designed to run up, over, and behind the ears,
joining behind the head and running down the back. Please refer to the 3DME
Owner’s Manual for details on connecting to the bodypack.
For a video on proper IEM insertion, visit YouTube/Sensaphonics: https://www.
youtube.com/watch?v=rDC3lKJ4FcQ
1 2 3

Once the earpiece is fully inserted, (4) tuck the upper (helix) portion
of the earpiece under the fold of your upper ear and into the (5) lower
notch. Don’t be afraid to push it all the way in! Then, (6) firmly bend the
cable behind your ear, shaping its internal memory wire to follows the
contour of your ears. Running the cable behind your head, repeat to
insert the other earpiece.
Cable replacement: The cable is attached with a small nylon
screw in each earpiece. To install, (1) match the 4-pin cable plugs
to the correct earpieces (blue = left, red = right). (2) For each earpiece,
remove the nylon screw, then unplug the cable. (3) Insert the 4-pin
connectors, making sure the cable runs in the same direction as the
original. (4) Secure cable using the new nylon screw.
4 5 6

These custom-fit soft silicone IEMs will provide
outstanding comfort and industry-best
isolation, with a persistent seal. If you are
unsure whether your earpieces are properly
fitted, use the Sensaphonics Audio Seal Test,
available on the 3DME bodypack, to check.
For full details, see the Owner’s Manual.
Technical Specifications
3DME Custom Tour IEMs carry the same
specifications as the standard universal-fit
version, as listed in the Owner’s Manual.
Sensaphonics, Inc.
660 N. Milwaukee Ave.
Chicago IL 60642
Phone: [phone]
Email: [e-mail]
© 2021 by Sensaphonics, Inc.