SensLights SLDY347 User manual

SLDY347
1 / 4
www.senslights.com Email:[e-mail]
No Wiring …. No electricity!
Product name: Solar Powered wall Light SLDY347
Housing Material
Engineering plastics +PC
Body Color
black
Solar Panel
2 W high-efficiency Polycrystalline PV module
Battery
1 x 3.6V 2200mAh Ni-Mh batteries maintenance free
Controller
Intelligent controller:light/time intelligent control, waterproof, IP
44 guard level;various
protections,over charge and over-discharge protect function
LED Source
4 pcs 0.5w LEDs high brightness LED
LED colors
white
Average operation time
6-8 hrs/day
Charging time
4 -5 hours
Working time
5-6hours,battery capacity providing 2-
3continuous cloudy or rainy days backup
Temperature Range
-40 -- +50 Degree
Protection
IP44

SLDY347
2 / 4
www.senslights.com Email:[e-mail]
No Wiring …. No electricity!
Location of the Solar Light
1) The solar light must be located in a position where it can get direct
sunlight on the solar panel, and generally free from cover and
shade. When locating a suitable position for the unit, remember
that it detects an area of about 45-50 degrees vertically and about
90-120 degrees horizontally, with a range of over 5 meters.
2) The solar light must be left to charge for 2 sunny days before first
time use so that best results are achieved.
Assembly Instructions
Lamp installations
1) Choose the wall you want to set and signed with the 4 holes.
2) Burrowed with Inflatable Screws on the 4 holes.
3) Hang the lamp onto the wall base plate .

SLDY347
3 / 4
www.senslights.com Email:[e-mail]
Operation
1) Turn the button to the “LOW/HIGH” position so that the batteries can fully charge before use.
2) After the initial 2-day charging period, your solar lights are ready for
use. Your light will now function automatically.
Replacing the Batteries
1) Take off the 4 screws with screwdriver and replace the
old Ni-Mh batteries. Make sure the new batteries are Ni-
Mh rechargeable batteries.
2) Install the new batteries in to the battery
compartment, ensuring the correct polarity is
observed.
3) Reassemble the unit by reversing the above procedure.

SLDY347
4 / 4
www.senslights.com Email:[e-mail]
Trouble Shooting
If your solar light does not come on at dusk despite observance of all the instructions, please
try the following steps:
1) Make sure that the solar light is not being affected by any other light source.
2) Ensure the solar light does not stand in the shade during the day.
3) Make sure the switch is in the auto position.
4) Check that the batteries are installed correctly.
Maintenance
Clean the solar module regularly with a damp towel to guarantee optimum performance of the
solar panel. Do not use any type of solvent for cleaning and be careful not to put too much
pressure on the module while cleaning.
If you need any support please contact: [e-mail]