sensolus TRACK 1020 Use and care manual

www.sensolus.com | [email protected]om
TRACK 1020 Battery replacement manual
Step 1
• Turn the tracker face down.
• Unscrew the 6 screws.
Tip: If using a power drill, use power seng 7, on low. (Note:
not all power drills have the same sengs!)
Step 2
Remove the back plate and the 6 screws.
Step 3
Remove the circuit board and the baery pack.
Step 4
Turn around the circuit board and baery pack
Step 5
Remove the baery pack - pull them out of the
connector.
Step 6
Add a new baery pack, be carefull with the connector.
A green LED will blink when the baery pack is
connected.
Step 7
Reinsert the circuit board and baery pack.
Make sure the LED is facing downward and the foam on
the baery is facing upwards.
Step 8
Close the case again by ghtening the 6 screws in the
corresponding holes. Be careful not to break the casing
when using a power drill.

www.sensolus.com | [email protected]om
Indicate baery replaced in plaorm
When you replaced the battery in the tracker you have to indicate
thet in the platform.
• Go to the tracker details page in the general secon. You can
search for this tracker or nd in in the asset list or asset map.
• Click on the replace baery link to indicate you have replaced the
baery of that tracker.
• Conrm the update.