Sentinel PA0223 User manual

-1 - -2-
User Manual
Water Boiler
Model No. PA0223
READ CAREFULLY THIS INSTRUCTION BEFORE USE
AND SAVE FOR FUTURE REFERENCE
HOW TO USE
1. Remove all packing material before use. You must
clean your urn before the first use.
To clean the urn, fill with water to the “MAX” level.
Repeat the procedure several times to remove the
dust or residue from the urn.
2. Turn the lid counter clockwise to open.
3. Fill the tank with tap water and make sure the water is
below the "MAX”water level indicator.
4. Replace the lid and turn clockwise to lock into place
5. Connect the plug to the socket. Switch the urn ON.
The "HEATING" pilot lamp will light up and the water
will start to heat up. It continually works this way until
the "HEATING" pilot lamp goes out and the "KEEP
WARM" pilot lamp illuminates, letting the operator
know that the appliance is now preserving the heat.
6. Use the faucet to dispense water.
7. When about 3 cups of water remains in the tank, turn
the appliance off and unplug it from the electric
outlet.
8. Always make sure at least 3 cups of liquid are
remaining in the tank to prevent the boil-dry accident.
SAFETY CUT OUT
Urns feature a boil dry protection system, which will
switch off the element if the water level is too low. To
reset the safety cut out, switch off and unplug the urn and
allow it to cool. Empty out the water and press the RESET
button underneath the urn. Refill with cold water and
switch the urn back on again. The urn will automatically
reboil.
Cool-touch
lid handle
Water gauge
On/Off switch
Cool-touch
lifting handles
Light indicator
IMPORTANT SAFETY INFORMATION
Pull down lever with
tap

-3- -4-
Do not touch metal parts of the urn as they become
hot during use.
Be mindful of hot steam coming from the lid vents
Do not leave electrical appliances unattended when
in use
Always put the urn on a clean, level surface that can
withstand the weight of the urn - including water.
Always switch off and disconnect the urn from the
mains supply before cleaning or when not in use.
NEVER attempt to move the urn when it is full of hot
(or cold) water.
Do not allow the urn to be immersed in liquid.
Do not attempt to disassemble the urn –there are no
user serviceable parts inside.
ALWAYS disconnect from the outlet and allow the
water to cool completely before attempting to clean
or descale the urn.
NEVER OVERFILL THE URN
Do not allow cold water to sit in the urn for more
than 2 days as it could become stagnate and stale. If
this occurs, empty the water out completely and refill
with freshwater.
Your appliance must never be switched on through an
external timer or any kind of separate remote control
system.
This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and
knowledge.
POWER SUPPLY
If the unit uses a mains supply, ensure that the plug
is securely inserted into the mains socket and it is
easily accessible.
Protect the power lead from sharp objects,
excessive heat and damp or wet locations.
Check the power lead periodically, and replace if
damaged.
Check that the voltage on the rating plate of your
product corresponds with your local electricity
supply which must be A.C. (Alternating Current).
Any repairs should only be carried out by a fully
qualified electrician or an authorized service agent.
If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
ELECTRIC CIRCUIT DIAGRAM
DO NOT POSITION THE URN SO THAT THE TAP HANGS
OVER THE COUNTER EDGE. IT IS NOT DESIGNED TO BE
USED THIS WAY AND COULD LEAD TO SERIOUS SCALDS
SHOULD THE TAP BE SWITCHED ON BY MISTAKE.