Sequent SuperCharger2 User manual

Sequent SuperCharger2 is the world’s rst self-charging
automatic smartwatch providing cutting edge health and activity monitoring functions.
Our mission is to create sustainable and autonomous solutions for wearables
with the sole goal of improving people’s quality of life.

SuperCharger indicator
What does the subdial display?
• Default shows Activity level for the day
• 2 taps on the crown shows energy reserve
• 4 taps on the crown displays HR (for HR model)
• After 5 seconds indicator returns to the activity level
Activate and sync
1. Download and install the latest version of the Sequent app from
www.sequentworld.com/sequentapp
2. Double-tap the watch crown to wake up the watch. The watch will
blink blue once
3. Wait 10 seconds then place the watch for an hour on the charger
4. Once the watch has been charged, double tap the crown to activate
the sync-mode
5. Open the app and follow the instructions
SuperCharger2
Minute hand
SuperCharger indicator Crown
LED indicator
Hour hand

LED indicator
What do the dierent ashes of the watch LED mean?
• Single blue ash conrms the watch has been awakened by double
tapping the crown
• Blue ickering means the watch is connected to the phone and is
transmitting information
• Red pulsing shows when the heart rate sensor is active
• Red blinking indicates charging
• Blue blinking indicates fully charged
Start a basic sport mode session
• Long press for 2 seconds then quick tap twice (LED will ash purple
once to conrm)
- Watch hands countdown 30 minutes
- HR models will measure HR once every 5 minutes
• Triple tap to end sport mode and return to regular time display

Key information
Why does the watch go to sleep in normal mode?
• To save as much power as possible
Why does the watch keep disconnecting from the mobile app after
5 minutes?
• To save as much power as possible
What to do when I experience any problems or unexpected behavior
of the app?
• Force-close the app and start it again
How do I reset my watch?
• Hold 30 seconds to initiate reset (may clear memory and settings!!!).
Purple LED will ash 3 times to verify completion of reset
Start a detailed sport mode session
• Long press for 2 seconds then quick tap four times (LED will ash
purple twice to conrm)
- Watch hands countdown 60 minutes
- HR models will measure HR once every 2 minutes
- e-GPS will be triggered to start recording if signal is available
- Warning: When Detailed Sport Mode is on please expect a higher
energy consumption, you might need to charge your watch after
• Triple tap to end sport mode and return to regular time display
Quick Heart rate measure
Instant read (HR monitor without using the app)
• Tap 4 times quickly to initiate a quick measurement (lower accuracy,
display up to 160 HR)
• The red LED will ash to indicate reading has initiated, then ash 3
times to indicate the reading has nished and the subdial hand will
indicate the HR with the subdial.

Legal notice
By using your SuperCharger2 you expressly agree to the Sequent
Terms and Conditions available on our website. This product is not a
medical device and should not be used to diagnose or treat any med-
ical condition.
Personal data
Make sure you have read our privacy policy, which you can nd on our
website.
Safety instructions
• Use the product at temperatures between 0°C and 35°C (32°F and
95°F).
• Product may be stored in a clean, dry location between -5°C and
55°C (23°F and 131°F) when not in use.
• Avoid any extreme temperature changes.
• Avoid any kind of shocks, be they physical, thermal or otherwise.
They may damage internal and external components of your watch.
• Do not attempt to open, disassemble or tamper with the Product. Sub-
stances contained in this Product and/or its battery may damage the
Hardware Specication
• Low Energy Wireless (2.4 GHz)
• Lithium Polymer Battery 3.7V 45mAh
• 3 Analog hands
• 1 Crown (push button input)
Mobile Phone Support
• Android 7.0 and higher
• iOS 11 and higher
Help
Do you have issues with your watch? Visit www.sequentworld.com or
contact our Customer Service team.

Water resistance
• Your SuperCharger2 can withstand a pressure similar to that of a
50 m (165 ft) depth. You can, therefore, use it when dishwashing,
splashing or swimming. However, it can’t be used for diving or snor-
keling.
• Do not press the Crown of your watch when it is under water.
• Avoid long exposure to salt water. Make sure you rinse your watch
with fresh water after spending time swimming in salt water.
Warranty
Find out more about your warranty on
www.sequentworld.com/pages/authenticity-warranty
environment and/or human health if handled and disposed of improperly.
• Do not use the Product in circumstances that could cause a dangerous
situation, such as using the Product while operating heavy machinery
or driving a moving vehicle in a manner that might cause you to take
your eyes o the road or become so absorbed in the activity that your
ability to concentrate on the act of driving becomes impaired.
• Do not wear or clean your Product while you are charging it. Always
unplug the charger rst before cleaning the Product.
• Do not use abrasive cleaners to clean your Product.
• Do not place your Product in a dishwasher, washing machine, micro-
wave oven, oven, dryer.
• Do not use your Product in a sauna or steam room.
• Do not expose your Product to water at high pressure, such as
ocean waves or a waterfall.
• Do not leave your Product in direct sunlight for an extended period
of time.
• Do not leave or use your Product near open ames.
• Never allow children to play with the product; the small components
may be a choking hazard!
• The Product is not intended for use where the failure of the Product
could lead to death, personal injury, or severe environmental damage.

Caution:
Any changes or modifications not expressly approved by the grant-
ee of this device could void the user’s authority to operate the
equipment.
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause unde-
sired operation.
RF EXPOSURE WARNING
The equipment complies with FCC RF exposure limits set forth for an
uncontrolled environment.
The equipment must not be co-located or operating in conjunction
with any other antenna or transmitter.
CANADA, INDUSTRY CANADA (IC) NOTICES
This device complies with Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may
not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
Regulations
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE
STATEMENT
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment o and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit dierent from that to
which the receiver is connected.
• Consult the dealer or an experienced radio or television technician for help.

CAN ICES-3 (B)/NMB-3(B) (CANADA)
This digital apparatus does not exceed the Class B limits for radio noise
emissions from digital apparatus set out in the interference-causing
equipment standard entitled: “Digital Apparatus,” ICES-003 of the Ca-
nadian Department of Communications.
Cet appareil numérique respecte les limites bruits radioélectri-
ques applicables aux appareils numériques de Classe B prescrites
dans la norme sur le matériel brouilleur: “Appareils Numériques”,
NMB-003 édictee par le Ministre Canadian des Communications.
This device complies with Industry Canada license-exempt RSS stand-
ard(s). Operation is subject to the following two conditions: (1) this de-
vice may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired opera-
tion of the device.
Le présent appareil est conforme aux CNR d’lndustrie Canada applica-
bles aux appareils radio exempts de licence. L’exploitation est autorisée
aux deux conditions suivantes : (1) l’appareil ne doit pas produire de
brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage
radioélectrique subi, méme si le brouillage est susceptible d’en com-
promettre le fonctionnement.
CANADA, AVIS D’INDUSTRY CANADA (IC)
Cet appareil est conforme avec Industrie Canada exemptes de li-
cence RSS standard(s).
Son fonctionnement est soumis aux deux conditions suivantes : (1)
cet appareil ne doit pas causer d’interférence et (2) cet appareil doit
accepter toute interférence, notamment les interférences qui peu-
vent aecter son fonctionnement.
INFORMATIONS CONCERNANT L’EXPOSITION AUX FRÉQUENCES
RADIO (RF)
La puissance de sortie émise par l’appareil de sans l est inférieure à la
limite d’exposition aux fréquences radio d’Industry Canada (IC). Utilisez
l’appareil de sans l de façon à minimiser les contacts humains lors du
fonctionnement normal.
Ce périphérique a également été évalué et démontré conforme aux
limites d’exposition aux RF d’IC dans des conditions d’exposition à
des appareils portables. (les antennes sont moins de 20 cm du corps
d’une personne).

EUROPE (CE DECLARATION OF CONFORMITY)
Hereby, Sequent Ltd., declares that this product is in compliance with
the essential requirements and other relevant provisions of Directive
2014/53/EU.
Intellectual Property
All Intellectual Property, as dened below, owned by or which is oth-
erwise the property of Sequent or its respective suppliers relating
to this product, including but not limited to, accessories, parts, or
software relating there to (the “Product System”), is proprietary to
Sequent or its licensors and protected under Federal laws, state
laws, and international treaty provisions. Intellectual Property in-
cludes, but is not limited to, inventions (patentable or unpatentable),
patents, trade secrets, copyrights, software, computer programs,
and related documentation and other works of authorship. You may
not infringe or otherwise violate the rights secured by the Intel-
lectual Property. Moreover, you agree that you will not (and will not
attempt to) modify, prepare derivative works of, reverse engineer,
decompile, disassemble, or otherwise attempt to create source
code from the software. No title to or ownership in the Intellectual
Property is transferred to you. All applicable rights of the Intellectu-
al Property shall remain with Sequent and its licensors and suppliers.
Disposal and recycling information
The symbol indicates that this Product shall not be mixed with unsort-
ed municipal waste when disposed of. There is a separate collection
system for waste electrical and electronic equipment. Usually old
electrical and electronic equipment can be returned free of charge.
For further information please contact the competent municipal
authorities or the shop where you purchased the Product. Correct
disposal ensures that waste electrical and electronic equipment is
recycled and reused appropriately. It helps avoid potential damage to
the environment and human health and to preserve natural resources.

Do not dispose of the Product with household waste. Batteries are
not to be disposed of in municipal waste streams and require sepa-
rate collection.
Disposal of the packaging and your Product should be done in accord-
ance with local regulations.
NCC 警語:
經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者
均不得擅自變更頻率、加大功率或變更原設計之特性及功能。
低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現
有干擾現象時，應立即停用，並改善至無干擾時方得繼續使用。
前項合法通信，指依電信法規定作業之無線電通信。低功率射頻電機
須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。