Shisha-Turbine Turbo User manual

The Shisha-Turbine® is an electrical igniter for charcoals. The product
is patented, design and brand are protected.
The heating spiral consists of specially designed, heat resistant
stainless steel and is TÜV-certificated. It was particularly developed
and produced for the Shisha-Turbine®. The Shisha-Turbine® performs
at 705 Watts at a supply voltage of 230V.
The special feature is a fan, quasi the igniter's turbo.
This turbo effect makes a faster, smoke-free igniting process as well
as clearly better blazing of the charcoals possible.
Time as well as electrical energy are also saved, at the same time the
temperature of the case is kept low. This product is substantially safer
than other charcoal igniters on the market.
The Shisha-Turbine® can ignite up to 10 pcs. of charcoals. The charcoals
are ready after 5 to 7 minutes depending on the producer and the amount
of the charcoals.
Instruction Manual

Shisha-Turbine® Turbo
Take off - Manual:
1. Place the charcoals on the cold heating spiral. (max. 10 pcs.)
2. Plug in the power cord.
3. Turn the charcoals around after approximately 3 minutes.
4. Take the charcoals out after approximately 3 minutes.
(Don’t leave charcoals lying on the heating spiral!).
5. Remove the power plug.
6. Let the Shisha-Turbine® Turbo cool down.
Safety notes:
Don’t cover the device at any time!
Only for private use!
Only use the device outdoor!
Don’t put the device in touch with water!
Use a fireproof underlayment!
Don’t touch or move the device during operation!
Don’t let the device out of sight!
Let the device cool down completely!
The appliance can be used by children aged from 8 years and persons with reduced physical,
sensory or mental capabilities or lack of experience and knowledge, if they have been given
supervision or instruction concerning use of the appliance in a safe way and understand the
hazards involved. Children shall not play with the appliance and have to be supervised not to
play with the appliance!
Do not allow the hot parts of the fire lighter to touch the cord or other flammable materials!
Cleaning and user maintenance shall not be made by children without supervision!
The power cord of the Shisha-Turbine® can not be replaced. By damaging it, the device
has to be scrapped!
Maintenance note:
We recommend to clean the heating spiral of your Shisha-Turbine® after every 5th
usage with a wire brush and compatible oil. The best way to handle this is with our
Protect&Care Set, which lets you follow these steps:
1. You unplug your Shisha-Turbine® from the power supply.
2. Roughly remove residues from the heating spiral with our Cleansing Brush.
3. Take a paper towel, give a few drops of our Protect&Care Oil on it and remove the
residues from the heating spiral.
4. Use another paper towel and wipe the spiral clean.
5. If consistent residues still appear, repeat steps 3 and 4 until you no longer detect
residues.
6. Finally plug in your Shisha-Turbine® and let it run without charcoals, until the oil
residues are burned.
After that you can light up your charcoals as usual.
This instruction manual can also be downloaded following the link below:
www.shisha-turbine.de/wp-content/uploads/2018/08/ST-Turbo_Instruction-Manual.pdf
Contact:
[email protected]
www.Shisha-Turbine.de