SIK-Holz Cat User manual

min. 1.50
2,50
0,0
topview with
minimum safety area
1
2
3
4
5
Pos. .02
l 4.30
6
7
8
10
9
11
12
13
14
Pos. .01
h 1.80
19
18
16
17
15
20
21
P1
P2
P3
P4
P5
P6
P7
22
Pos. .01
h 2.10
Pos. .02
l 4.10
Pos. .01
h 2.10
23
Pos. .01
h 3.40
with step h 1.65
Pos. .02
l 5.00
1
2
24
3
Pos. .02
l 4.50
h 2.05
5
4
6
7
8
9 10 13
12
11
Pos. .02
l 2.00
Pos. .02
l 3.40
lower edge h 2.20
Pos. .01
h 2.10
Pos. .01
h 2.10
Pos. .01
h 2.90
Pos. .01
h 2.10
Pos. .01
h 1.40
Pos. .01
h 2.70
(2.65)
Pos. .01
h 3.20
Pos. .01
h 2.20
Pos. .02
l 2.50
h 80
Pos. .01
h 3.90
Pos. .01
h 2.90
h 75
h 2.70
h 2.55
h 1.65
h 1.65
h 2.50
h 1.70
h 1.35
h 1.55
h 1.80
h 2.75
h 1.45
h 1.85
lower edge
h 1.30
h 1.25
h 2.90
h 80
h 80
h ~50
h 2.15
h 55
h 2.10
h 70
h 1.15
Pos. .07
Horizontal net IV
ca. 0.45/1.40 x 1.75
Pos. .06
Horizontal net III
~ 1.50 x 1.50
Pos. .01
h~50
Pos. .05
Horizontal net II
~ 60 x 1.00
Pos. .04
Horizontal net I
~ 2.75/4.60 x 2.25
Pos. .03
l 2.00
Pos. .03
l 4.20
h 30
Pos. .03
l 4.05
Pos. .03
l 1.95
Pos. .03
l 1.65
l 3.65; h 2.10
Pos. .03
Pos. .03
l 2.60
lower edge h 2.15
Pos. .03
l 3.10
h 1.90
Pos. .03
l 2.80
Pos. .03
l 4.20
h 2.25-2.05
Pos. .03
l 2.50
Pos. .03
l 2.65
h 75
Pos. .03
l 1.90
h 65
Pos. .08
lanted net ascent I
Pos. .9
lanted net ascent II
(2.30)
Climbing post
h 3.00
with step h 1.40
Pos. .10
Double balancing rope
with support rope
Pos. .11
2x Vertikal
Climbing Rope
Climbing post
h 3.00
(1.85/2.85)(1.35/2.35)
Pos. .12
Hanging rope traverse
(1.25/
2.55)
(1.05)
(90/2.30)
(65)
(40/1.60)
Pos. .14
Balancing beam h 55
with support rope (1.35)
h 1.70
h 1.90
h 2.80
h 2.40
h 2.50
h 1.80
h 1.80
Pos. .13
Climbing labyrinth
Climbing Balancing Unit »Cat«
© SIK-Holzgestaltungs GmbH
1/3
scale:
date:address:
page:project:
advisor:
article or
pos ID:
project ID:
Climbing Balancing Unit »Cat«
fall height
3,0m
The minimum area must be free of obstacles to/on which the user can during his movement unexpectedly fall or crash
Hard and sharp objects, as well as trip-surfaces count as obstacless
drawing type
24 10 2019 max
A4; 1:50
Master enterprice of woodcarving handicrafts
2 12 116
assembly
order no :
V Liehr
editor:

view
55
side view
perspective
- without scale -
Climbing Balancing Unit »Cat«
© SIK-Holzgestaltungs GmbH
2/3
scale:
date:address:
page:project:
advisor:
article or
pos ID:
project ID:
Climbing Balancing Unit »Cat«
fall height
3,0m
The minimum area must be free of obstacles to/on which the user can during his movement unexpectedly fall or crash
Hard and sharp objects, as well as trip-surfaces count as obstacless
drawing type
24 10 2019 max
A4; 1:50
Master enterprice of woodcarving handicrafts
2 12 116
assembly
order no :
V Liehr
editor:

25
1,25
75
10
5
2,05
85
20
15
1,05
7575
40
40
0,0
foundation plan
on building site
because of crooked trees different
measures are possible
check measurements
1
2
3
4
5
6
7
810
9
11
12
13
14
19
18
16
17
15
20
21
24
22
23
55
40
60
foundation detail
minimum soil class III;
make foundation bigger
check compression or
without scale
concrete
min.
slanted net entrance
min.
concrete
gravel
gravel
min.
climbing rope
min.
min.
concrete
gravel
pole
min.
min.
climbing pole
concrete
gravel
min.
min.
concrete
gravel
pole
min.
min.
pole
gravel
concrete
perspective
without scale
© SIK-Holzgestaltungs GmbH
3/3
scale:
date:address:
page:project:
advisor:
article or
pos. I :
project I :
Climbing Balancing Unit »Cat«
fall height
3,0m
The minimum area must be free of obstacles to/on which the user can during his movement unexpectedly fall or crash.
Hard and sharp objects, as well as trip-surfaces count as obstacless.
drawing type
24.10.2019 max.
A4; 1:50
Master enterprice of woodcarving handicrafts
2.12.116
assembly
order no.:
V.Liehr
editor:
Climbing Balancing Unit »Cat«

ASSEMBLING INSTRUCTION
Rev. 09.2021 Page 1 von 2 MASTER ENTERPRISE OF WOODCARVING HANDICRAFTS / © SIK-HOLZGESTALTUNGS GMBH
FURTHER INFORMATIONS: SIK-HOLZGESTALTUNGS GMBH, LANGENLIPSDORF 54 A, D-14 13 NIEDERGÖRSDORF; +4 (0)33742.7 0; WWW.SIK-HOLZ.DE; [e-mail]
2.12.116 Climbing Balancing Unit „Cat“
Scope of delivery
Amount Denomination easure
2 climbing posts at 160 kg 320 kg
17 posts à 65 kg 1105 kg
2 tree trunk stairs at 100 kg 200 kg
18 round woods at 35 kg 630 kg
climbing labyrinth
- 5 posts
- 3 support ropes ø 18 mm
- 5 balancing ropes ø 24 mm
250 kg
1 rotating balance beam 50 kg
2 support ropes ø 18 mm at 2 kg 4 kg
2 slanted net ascents with ground anchor plates at 15 kg 30 kg
1 double-balancing rope 10 kg
2 climbing ropes with climbing supports and 1 ground anchor plate at 10 kg 20 kg
1 rope traverse 10 kg
4 climbing nets at 15 kg 60 kg
Sum approx. 2689 kg
All weights are approximate. The heaviest component is highlighted in bold.
Tools
-spade, shovel, tape measure, spirit level, hammer and ladder
-socket wrench 17 / 19 mm, screwdriver with insert Torx Bit (TX 10-30)
-2 persons (2 installers at 36 h), telescopic loader with palette fork, mini excavators
-approx. concrete 4.8 m³ C 20/25
Assembling
-First, the playing surface (security area) should be measured, set the point (height) and the start point (climbing
post 23) can be determined.
-Determine the foundation positions according to plan. easures are to the check by the client/customer,
because of the natural growth forms of the wood. To determine the position of the foundations, use the
attachment parts.
-Digging holes depending on the section for the Climbing Unit and depending on the ground conditions a
drainage layer, for example gravel layer 10 cm in order to prevent stagnant moisture.
-In the foundation area of the post is to follow the included steel reinforcement.
-Installation depths (cut) on the stand post are to consider.
-Lift the posts and attachment parts one after another into the prepared holes to adjust by means of spirit level
and make them solid.
Attention: if not adequately secured play towers or attachment parts may be tipping!
-Attachment parts one after another according to marking (Number on number and/or letter on letter / numbers
indicate in brackets the screw length) mount.
-Information: Flexible attachments are to install with a slight sagging (please not too tight). To consider is the
connection of the eye bolts in the direction of the pull of swing, bridge, nets and ropes. Please remove the nets
and ropes –after the making of the concrete, if the use (the playing of the children) can not excluded.
-After everything is assembled and aligned, the foundation according to the drawing can be properly completed.
-After 3-5 days of curing time, tightening all screw joints and which fill game surface again.
-Transportation braces and installation damage are to be removed after installation on site, grind and paint
damaged areas.
Notice: concrete needs about 28 days in order completely to harden.
Security guidelines
During assembly and transport on site, play towers and/or attachment parts must always be adequately secured,
either through technology or through attached transportation bracing.
Required safety areas/ falling space around equipment are indicated on the installation drawings.

ASSEMBLING INSTRUCTION
Rev. 09.2021 Page 2 von 2 MASTER ENTERPRISE OF WOODCARVING HANDICRAFTS / © SIK-HOLZGESTALTUNGS GMBH
FURTHER INFORMATIONS: SIK-HOLZGESTALTUNGS GMBH, LANGENLIPSDORF 54 A, D-14 13 NIEDERGÖRSDORF; +4 (0)33742.7 0; WWW.SIK-HOLZ.DE; [e-mail]
Playground equipment with a potential height of fall of more than 600 mm and/or a forced movement require an
impact attenuating/ shock-absorbing surface in the whole impact area below them according to the EN 1176 and
EN 1177. (Non-shock-absorbing undergrounds are for example without limitation: bricks, stones, concrete, bitumen
and wood.)
Preventive maintenance instructions
An operational check of the equipment must be carried out 2 weeks after installation. Here the main attention
should be paid to tight screw joints and stability. In general the equipment should be checked on a regular basis. A
visual routine inspection should be carried out on a weekly basis. An operative inspection should be performed
every 1–3 months and the general or main inspection has to happen on an annual basis. We recommend to check
stability of posts once a year and to expose foundations, let them dry and to repaint them also below ground level
above the foundation with a solvent free glaze. (Further information concerning maintenance can be found in
our Checklist for aintenance/ Inspection , in our General aintenance Notes and also in our catalogues, as well
as on our website www.sik-holz.de/en)