Silent Disco King Bob User manual

Howitworks
Step one
Set up transmitters and start
playing audio.
Step four
Adjust the volume by scrolling the
volume wheel.
Step two
Switch the headphones on. Hold
the power button until LED power
light shows.
Troubleshooting
Check out the back of this sheet
for tips on solving problems that
you may run into.
Step three
Tapping the power button to
change channel. The LED light
will change according to the
channel.
Step five
If needed, remove the right
headphone cap and replace with
2 x AAA batteries.
1
4
2
5
3
Something not working? Visit silentdiscoking.com/help or call our 24/7 support line 0207 0603 653
Setting up your Bob Headphones

In detail
[e-mail] • silentdiscoking.com • @silentdiscoking
a
b
c
d
e f
a
d
b
e
c
f
Power / channel LED
Illuminates when the
headphones are on and
indicates channel.
Aux socket
Can be used to connect input
or use as output.
Power channel button
Switches headphones on / off
and selects channel.
Battery cover
Push the clip on to remove the
cap and replace the batteries.
Folding hinge
Use to fold headphones when
they are not in use.
Volume wheel
Scroll to adjust audio input
volume.
Troubleshooting
No Audio?
• Check your music playing device is working, connected
correctly, playing music with volume turned up full.
• Try a different device and audio cable.
• Ensure receivers / headphones are switched on,
connected to correct channel and have volume up.
No Power?
• Check the transmitter is fully charged / plugged in
correctly and switched on.
Signal cuts out, interference or reduced range?
• Ensure there is no interference caused by other wireless
equipment in the vicinity.
• If using 2 or more transmitters simultaneously make sure
each is on different channels (frequencies). You cannot
use 2 transmitters on the same channel in the same
place. They will cancel each other out, resulting in little
or no signal.
• Make sure the transmitter is in range.
Something not working? Visit silentdiscoking.com/help or call our 24/7 support line 0207 0603 653