SINOX Connectech CTB0131 User manual

CTB0131

21
NOTE: Read the entire instruction manual before you start installation and assembly.
WARNING
Component Checklist
IMPORTANT: Ensure that you have received all parts according to the component checklist prior to installation.
If any parts are missing or faulty, telephone your local distributor for a replacement.
ST6.3x55 (x3)
W-A
concrete anchor (x3)
W-B
D6 washer (x3)
W-C
articulated arm assembly
A
• Do not begin the installation until you have read and understood all the instructions
and warnings contained in this installation sheet. If you have any questions
regarding any of the instructions or warnings, please contact your local distributor.
• This mounting bracket was designed to be installed and utilised ONLY as
specified in this manual. Improper installation of this product may cause damage
or serious injury.
• This product should only be installed by someone with good mechanical ability
who has basic building experience and fully understands this manual.
• Make sure that the supporting surface will safely support the combined weight of
the equipment and all attached hardware and components.
• If mounting to wood wall studs, make sure that mounting screws are anchored
into the center of the studs. The use of a stud finder is highly recommended.
• Always use an assistant or mechanical lifting equipment to safely lift and position
the equipment.
• Tighten screws firmly, but do not over tighten. Over tightening can cause damage
to the items, This greatly reduces their holding power.
• This product is intended for indoor use only. Using this product outdoors could
lead to product failure and personal injury.
Package M
Package W
D5 washer (x4)
M-C
M5x14 (x4)
M-B
M4x14 (x4)
M-A
Allen key (x1)
B

4
3
X X
√
WARNING
• Make sure that mounting screws are anchored into the center of the studs. The use of a stud
finder is highly recommended.
• Installers are responsible to provide hardware for other types of mounting situations.
• Installers must verify that the supporting surface will safely support the combined weight of the
equipment and all attached hardware and components.
2a. For Wood Stud Wall Mounting
Installers must verify that the supporting surface will safely support the combined weight of
the equipment and all attached hardware and components.
WARNING
2b. For Solid Brick and Concrete Mounting
Drill pilot holes
2
Drill pilot holes
3
Screw the wall
mount onto
the wall
Screw the wall
mount onto
the wall
X X
√
2
1
ø 4.5mm
(ø 3/16")
55mm
(2.2")
55mm
2.2"( )
55mm
(2.2")
Find and mark the exact
location of mounting holes
1
Mark the exact
location of
mounting
holes
60mm
(2.4")
60mm
2.4"( )
60mm
(2.4")
ø 10mm
(ø 3/8")
W-C W-A
W-C
W-A
W-B
1. Removing the VESA Plate
XX

65
Tighten all screws but do not over tighten.
Screw the VESA plate onto the display.
3. Installing the VESA Plate
TV
TV
TV
TV
4. Hooking the Display onto the Wall Mount
Insert the VESA plate into the mount rail. Tighten screw (that is previously removed) with a flat blade screwdriver.
B
It is necessary to slightly loosen
or tighten the adjustment screw
using an Allen key.
Top of the TV
wall
M-A
M-B
M-C