SIS Ergo M Wall User manual

5
1
2
4
3
6
D x 4 (M6x25)
RN-084
E x 6 (5x20mm)
R011530
F x 3 (Ø7,9 Cable Clamp)
R010230
G x 5 (4x16mm)
R011500
H x 1 (Hex Key 4mm)
R011921
I x 1 (Hex Key 5mm)
R011905
M Wall
Components Required:
Wall Bracket x 1 1.
Column x 1 2.
Plastic Cover x 1 3.
Top Bracket x 1 4.
Tabletop x 1 5.
Handle x 1 6.
Hardware Bag x1 7.
Hardware:
Page 1 of 3
Tools required: Drill Driver, PHILLIPS Bit PH2 and PH1
***For techinal support, please call 800. 374.7438 #2007 [email protected]***
C x 2 (M6x16)
RN-081
A x 4 (M8x20)
R011032
B x 2 (Ø6 Bushing)
R015637

2xC
4
3
2
1
2xA
4xD
2xA
2xC
2
3
Warning!! Do not
remove the
safety lock
before the table
is fully assembled
Assembly Steps:
1. Mount the wall bracket(1) to a wall using four suitable
screws.
2. Mount two (M8x20) machine screws(A) in the rear bottom
holes of the column(2). Mount two bushings(B) in the top of the
column, and place plastic cover(3) on column.
Tools required: Drill Driver, PHILLIPS Bit PH2 and PH1
***For techinal support, please call 800. 374.7438 #2007 [email protected]***
Page 2 of 3
3. Place column(2) on wall bracket(1), by aiming the two previous
mounted (M8x20) machine screws(A) after the rear holes in the
wall bracket.
4.Mount column to wall bracket using two (M8x20) machine
screws(A) and two (M6x16) machine screws(C).
5. Mount top bracket(4) to column(2) using four (M6x25) machine
screws(D).

5xG
3xF
6
5
6xE
5
4
Tools required: Drill Driver, PHILLIPS Bit PH2 and PH1
***For techinal support, please call 800. 374.7438 #2007 [email protected]***
Page 3 of 3
6. Attach tabletop(5) to top bracket(4) using six
(5x20mm) chipboard screws(E).
7. Attach handle(6) to tabletop(5) in a suitable position
and secure cable with cable clamps(F). Mount everything
using five (4x16mm) chipboard screws(G)
8. Remove safety lock from column(2) and push plastic
cover(3) downwards.