SKLZ PRACTICE PLAY WIN QUICKSTER Manual

Includes:
» 6' x 6' Quickster Net
» Removable Target
» Removable Ball Collection Skirt
» Carry Bag
» 4 Ground Stakes
SET-UP INSTRUCTIONS
QuicksterNets_6x6_InstrV1.indd 1 10/12/11 5:01 PM

WARNING: PLEASE READ!
Quickster™is under tension when assembled. Please take the utmost care when releasing
the tension during disassembly. Failure to do so may result in injury.
BEFORE YOU BEGIN:
» Adult assembly recommended.
» Make sure you have all of the Quickster components. Please contact SKLZ customer service
toll free at 877-225-7275 if you are missing anything.
» Read all setup and usage instructions carefully.
» When done, disassemble Quickster and store after use. Do not leave Quickster outdoors.
» Do not climb or hang on the Quickster.
» Regularly check for wear and tear. Stop using goal if any part of it breaks. Failure to do so
could result in injury.
» Keep away from re and heat sources.
» Not suitable for children under 3 years of age.
QUICKSTER PARTS:
A – Net B – Base Frame
C – Tension-Tite™Arm Pole (2)
F – Removable Ball Collection Skirt
D – Ground
Stakes (4)
E – Removable Full Swing
and Chipping Target
QuicksterNets_6x6_InstrV1.indd 2 10/12/11 5:01 PM

SKLZ.com
Removable Ball Collection Skirt (F)
Base Frame (B)
Net (A)
Removable
Full Swing &
Chipping Target (E)
Tension-Tite™Arm Pole (C)
QuicksterNets_6x6_InstrV1.indd 3 10/12/11 5:01 PM

QUICKSTER™ ASSEMBLY:
STEP 1–BASE FRAME AND TENSION-TITE™ ARM POLE ASSEMBLY
NOTE: Base Frame and Tension-Tite arm poles come pre-attached by elastic.
Layout one Tension-Tite Arm Pole (C) and link
together to form a straight pole. Repeat with second
Tension-Tite Arm Pole. Layout Base Frame (B) and
link the frame together. Make sure to secure the
poles with the push buttons.
NOTE: The slight bowing on the Base Frame is part
of the Tension-Tite system design.
Slide the Tension-Tite Arm Poles into each side of
the Base Frame.
NOTE: Ensure arm poles are fully inserted. Failure to
do so may result in damage to the Quickster.
STEP 2–CONNECT THE NET TO THE FRAME
Unfold the Net (A) and slide the metal pin at the top of the net into the top
of the Tension-Tite Arm Pole. Make sure that the Quickster logo on the net is
facing away from the frame. Repeat on the other side.
Lift up the base pole to connect the grommets on the bottom of the net to
each side of the frame.
NOTE: Check the frame to make sure it is securely and fully assembled with
the net before securing to the ground.
B
Push Button Attachment
C
C
1.
Grommet attachment
2.
1.
1.
2.
2.
QuicksterNets_6x6_InstrV1.indd 4 10/12/11 5:01 PM

SKLZ.com
STEP 3– ATTACH BALL COLLECTION SKIRT (optional)
Unroll Ball Collection Skirt (F) and velcro to the base of the Quickster Net.
STEP 4–ATTACH FULL SWING AND CHIPPING TARGET (optional)
Unfold the Target (E) and attach hook of the top strap through the loop ring of the metal pin
at the top of the Tension-Tite pole, repeat on the other side.
STEP 5–SECURE THE QUICKSTER™TO THE GROUND
Place Quickster in the desired location and ensure it is on
level ground. Secure frame with included Ground Stakes.
Ground Stakes can be secured with hand, foot or mallet.
NOTE: Do not use Ground Stakes on the back of the base
frame. Poles will bend and tension system will not
function properly.
NOTE: Care should be taken when pressing in the ground
stakes. Poles can be bent if driven too far into the
ground or hard surface.
CAUTION: Make sure the Quickster is secured into the
ground before play. During play make sure that
the Ground Stakes are secured regularly as a
loose Ground Stake may cause injury.
Top Attachment
ONLY secure stakes where
indicated above.
SIDE
QuicksterNets_6x6_InstrV1.indd 5 10/12/11 5:01 PM

STORING YOUR QUICKSTER™:
Remove the Pitching Target and Ball Collection Skirt (if using) fold up and place into the carry
bag. Remove the Ground Stakes and place them into the carry bag.
WARNING: Quickster is under tension when assembled. Please take the utmost care when
releasing the tension during disassembly. Failure to do so may result in injury.
Hold one pin in one hand and one Tension-Tite™ Arm Pole in the other while pulling the pin
out. Repeat on the other side. Remove the Net grommets from each side of the frame.
If needed, air dry the net before you fold and place it into the carry bag.
Pull the Tension-Tite™Arm Poles out of each side of the base frame and unlink and fold them
down to store.
NOTE: Store Tension-Tite™Arm Pole in the carry bag with the round tops facing away from
each other.
Unlock the push buttons on the Base Frame to unlink the frame. Fold and store in carry bag.
QuicksterNets_6x6_InstrV1.indd 6 10/12/11 5:01 PM

PERFECT FOR PRACTICE WITH:
» The only graphite hinged training club available
» Golf swing aws are immediately exposed by a break in the hinge
» The graphite shaft provides a more accurate weight and feel of a real driver
» Engineered to hit golf balls and teach a smooth, even-tempo golf swing
» Dual-colored shaft guides an on-plane swing (keep the black top visible
throughout the swing)
» Grip guide provides ideal placement for your hands in order to best square
the clubface
» Patented, two-way adjustable-hinged driver
» Includes adjustment key/divot tool
» Can be used anywhere you can swing a club
» Both fairway and rough surfaces
» Two tees for all range of clubs (oversized driver, fairway woods, irons)
» Practice driving, iron shots and short game
» Heavy-duty non-slip rubber hitting mat with realistic grass
HITTING MAT: TEE » FAIRWAY » ROUGH
HINGED GRAPHITE TRAINING DRIVER
QuicksterNets_6x6_InstrV1.indd 7 10/12/11 5:01 PM

90-DAY LIMITED WARRANTY – QUICKSTER™
Pro Performance Sports (PPS) warrants to the original consumer purchaser of any PPS product it manufactures that the product
will be free of defects in materials or workmanship for 90 days (unless specied in alternate warranties) from the date of purchase.
If defective, and purchased from a retail store, return the product along with receipt to the retail store where the product was
purchased. If the item was purchased from PPS, return the product along with proof of the date of purchase (i.e. the packing slip),
postage prepaid to the address below for replacement consideration:
Pro Performance Sports :: 5823 Newton Drive :: Carlsbad, CA 92008 :: Attn: Returns
This warranty does not cover damages resulting from accident, misuse, abuse or lost merchandise. Only valid in the USA. All
returns sent to PPS require a Return Merchandise Authorization number (RMA). For returns to PPS and for all other Customer
Service inquiries, please call toll free: 1-877-225-7275
Register your product at SKLZ.com to ensure warranty coverage, get new
product information and special deals from SKLZ
DO YOU HAVE A WINNING SPORTS PRODUCT OR IDEA?
Visit our website to learn how to submit a product application for consideration.
It may become our next winning product!
SKLZ.com
Made in China
©2012 Pro Performance Sports.
All rights reserved.
Unauthorized duplication is
a violation of applicable laws.
U.S. and Foreign Patents Pending.
VIDEOS
SKLZ.com
Like us on Facebook:
facebook.com/SKLZGolf
Follow us on Twitter:
@golfSKLZ
QuicksterNets_6x6_InstrV1.indd 8 10/12/11 5:01 PM