SKLZ QUICKSTER User manual

TENSION-TITE ARM POLES (2)
CORNER POCKET
CARRY BAG
NOTE:
Chipping target is pre-attached to the base poles.
Base poles and arm pole are pre-attached by elastic.
BASE POLE (3)
CHIPPING TARGET
Thank you for choosing SKLZ Quickster Chipping Net. We are dedicated to
providing you with the best tools and instruction possible to help you unleash your
athletic potential. If there is anything else we can do to help you optimize your
training, don’t hesitate to send us an email ([email protected]) or give us
a call (1-877-225-7275).
***IF YOU ARE MISSING ANY PARTS OR HAVE ANY PROBLEMS WITH
YOUR SKLZ PRODUCT, PLEASE CONTACT US ([email protected])
OR GIVE US A CALL (1-877-225-7275) AND WE WILL DO OUR BEST TO
MAKE IT RIGHT.***
BEFORE YOU BEGIN:
» Adult assembly required
» Make sure you have all of the Quickster Chipping Net components.
» Read all setup and usage instructions carefully.
» When done, disassemble Quickster Chipping Net and store after use. Do not
leave outdoors.
» Regularly check for wear and tear. Stop using net if any part of it breaks.
Failure to do so could result in injury.
» Keep away from fire and heat sources.
» Not suitable for children under 3 years of age.
iWARNING:
» Quickster Chipping Net is under tension when assembled. Please take the
utmost care when releasing the tension during disassembly. Failure to do so
may result in injury.
CHIPPING NET
QUICKSTER
INSTRUCTION MANUAL
COMPONENTS
PRACTICE
ChippingNet_Instru_2-sided_8x11_sV1.indd 1 1/17/14 3:40 PM

NOTE: Ensure all poles are fully inserted. Failure to do so may result in damage to the Chipping Net.
1 – Slide each of the Tension-Tite™ Arm Poles into the corresponding top corner pocket on the
Chipping Target.
Remove the Tension-Tite™ Arm Poles from the pockets on the Chipping Target.
WARNING: Chipping Net is under tension when assembled. Please take the utmost care when
releasing the tension during disassembly. Failure to do so may result in injury.
Disconnect the Base Poles from the corner joints and fold the frame so all of the poles lay parallel.
Roll up the Frame into the Chipping Target, and place into the Carry Bag.
STEP 1
BASE POLE ASSEMBLY
STEP 2
CONNECT THE CHIPPING TARGET TO THE TENSION-TITE™ ARM POLES
STEP 3
STORING YOUR QUICKSTER CHIPPING NET
1 – Insert each of the Base Poles into the holes of the
corresponding corner joints.
NOTE: Ensure are poles are fully inserted. Failure to do
so may result in damage to the Chipping Net.
VISIT SKLZ.COM FOR
INSTRUCTIONAL VIDEO AND CONTENT
Training Videos & Articles: SKLZ.com
facebook.com/SKLZgolf
twitter.com/SKLZ
SKLZ.COM
sV1
SETUP AND STORAGE
BASE POLES
TENSION-TITE ARM POLES
CHIPPING TARGET
(back side laying down)
AERIAL VIEW
BACK
VIEW
CORNER
POCKET
ChippingNet_Instru_2-sided_8x11_sV1.indd 2 1/17/14 3:40 PM