Smart Movt Technology Shaper User manual

1
Manual
Hybrid Smart Watch
Model:Shaper

2
1. Product Sketch

3
2. Operation Manual
2.1 Bluetooth
【1】 Check the status of the Bluetooth
a) Press the button of 3H;
b) if the 12H light is continuously on for 2 seconds, the watch is
connected with the phone; if the 12H light flashes for 2
seconds and 4 times each second, the watch is disconnected
with the phone; if the light does not shine, the Bluetooth is
off.
【2】 Turn on & off Bluetooth
Press & hold the 3H button for 3 seconds, light of 12H position will
flash continuously and the Bluetooth is on.
【3】 Bluetooth Reset
Press & hold the 3H button for 6 seconds, the 12H light flash once,
Bluetooth reset successfully when 12H light flashes 7 times.
2.2 Bluetooth connection
【1】 Click My Watch of APP to find out Device Settings and click
it, then click Pair and search for device named P3000(with
phone's Bluetooth on), and then click P3000 .

4
【2】 When connecting, 12H light (red & green) will flash
alternately flash for 3 seconds, shake the watch or press the
3H button will make the 12H light flash once, connection
completed.
2.3 UV
【1】 Press the 3H button twice in 0.5 second, 12H light will flash
once and the watch begins to detect UV index, then after 5
seconds;
【2】 if 12H light (red) flashes for 5 seconds and twice each second,
means very high risk of harm from unprotected sun exposure
and take extra precautions; if 12H light (yellow) flashes for 5
seconds and twice each seconds, means high risk of harm from
unprotected sun exposure and protection is needed; if 12H light
(green) flashes for 5 seconds and twice each seconds, means low
risk from the sun's UV rays.
Note: when phone is connected with the watch, you can check the UV index
through APP.
2.4 Find My Phone
Press the 3H button once, press again beyond 0.5 second but less
than 10 seconds.

5
Then 12H light (red) will flash once, the phone will be ringing.
2.5 Remote Shutter
【1】 Click the Remote Shutter of APP;
【2】 12H light (red) will flash once every 5 seconds;
【3】 shake your hand or press any button, the watch will flash once,
one picture taken.
2.6 Smart Time Sync
【1】 Click Smart Time Sync of APP;
【2】 Click Hands Calibration;
【3】 Follow the prompts, slide the virtual hands to the position to
be same as your watch.
2.7 Call Alert
when incoming a call, 12H light (red) will flash for 5 seconds and 4
times each second. (Call alert would be delayed for 5 seconds)
shake your hand or press any button of the watch, hang up the
phone.
Note: function available under connection between phone and watch, APP
must be granted permission from the phone.