
Notes
About
the
Discs
•To keep the disc clean, handle
the disc by its edge. Do not
touch the surface.
Dust, fingerprints, or scratches
on the disc may cause it to
malfunction.
•Do not expose the disc to
direct sunlight or heat sources
such as hot airducts,
or
leave it
in
acar parked
in
direct
sunlight as the temperature
may rise considerably inside
the car.
•After playing, store the disc
in
its case.
•Clean the disc with acleaning
cloth. Wipe the disc from the
center out.
•Do not use solvents such
as
benzine, thinner,
commercially available discI
lens cleaners, or anti-static
spray intended for vinyl LPs.
•If you have printed the disc's
label, dry the label before
playing.
•Do not use the following discs.
- A lens cleaning disc.
- A disc that has anon-
standard shape (e.g., card,
heart).
- A disc with alabel orsticker
on
it.
- A disc that has cellophane
tape or sticker adhesive on
it.
•Do not resurface the playing
side
of
adisc to remove
surface scratches.
Precautions
The power requirements and
power consumption
of
this
player are indicated on the back
of
the player. Check that the
player's operating voltage
is
identical with your local power
supply.
Power requirements and
power consumption
•
~~M'if·,t·
BOp·
XXX
X
lnU-RAY
DISCiD'IO
PUHf!,
......
At
OllllVDOHz
~
['o.:=:J
On
safety
•To prevent fire or shock
hazard,
do
not place objects
filled with liquids, such as
vases, on the player, or place
the player near water, such
as
near abathtub orshower room.
Should any solid object or
liquid fall into the cabinet,
unplug the player and have it
checked by qualified
personnel before operating it
any further.
•Do not touch the AC power
cord with wet hands. Doing so
may cause an electric shock.
On
placement
•Place the player in alocation
with adequate ventilation to
prevent heat build-up in the
player.
•Do not place the player on a
soft surface such
as
arug that
might block the ventilation
holes.
•Do not install this player in a
confined space, such
as
a
bookshelf or similar unit.
•Do not place the player
in
a
location near heat sources, or
in aplace subject to direct
sunlight, excessive dust, or
mechanical shock.
•Do not place the player
outdoors, in vehicles, on ships,
or on other vessels.
•
If
the player
is
brought directly
from acoldto awarm location,
or is placed
in
avery damp
room, moisture may condense
on the lenses inside the player.
Should this occur, the player
may not operate properly. In
this case, remove the disc and
leave the player turned on for
about half
an
hour until the
moisture evaporates.
•Do not install the player in an
inclined position. It
is
designed to be operated
in
a
horizontal position only.
•Keep the player and the discs
away from equipment with
strong magnets, such as
microwave ovens, or large
loudspeakers.
•Do not place heavy or unstable
objects on the player.
•Do not place any objects other
than discs on the disc tray.
Doing so may cause damage to
the player or the object.
•When you move the player,
take out any discs.
If
you
don't, the disc may be
damaged.
•When you move the player,
disconnect the
AC
power cord
and all other cables from the
player.
On
power
sources
•The player
is
not disconnected
from the AC power source as
long as
it
is
connected
to
the
wall outlet, even ifthe player
itself has been turned off.
•
If
you are not going to use the
player for along time, be sure
to disconnect the player from
the wall outlet. To disconnect
the AC power cord, grasp the
plug itself; never pull the cord.
•Observe following points to
prevent the AC power cord
being damaged. Do not use the
AC power cord if
it
is
damaged, as doing so may
result
in
an electric shock or
fire.
-Do not pinch the
AC
power
cord between the player and
wall, shelf, etc.
-Do not put anything heavy
on the AC powercord or pull
on the
AC
power cord itself.
"'continued 3