Notes on recording
• Betbre starting to lecold test the recolding fimction
to make stile the picture and sotmd are recorded
without any problems
• Compensation tbr the contents of recordings cannot
be provided, even if recording or playback is not
possible due to a malfimction of the camcorder,
storage media, etc
• TV color systems differ depending on the countries/
regions To view your recordings on a TV, you need
an NTSC system-based TV
• Television programs, fihns, video tapes, and mher
materials may be copyrighted Unauthorized
recording of such materials may be contrary to the
copylight laws
Notes on the LCD panel, viewfinder, and
lens
• The LCD screen and tile viewfinder are
manufactured using extremely high-precision
technology, so over 99.99% of the pixels are
operational for effective use
Howevel, there may be some tiny black points and/
or bright points (white, red, blue, or green in color)
that appear constantly on the LCD screen and the
viewfinder
These points are normal results of the manufacturing
process and do not affect the recording in any way.
• Exposing the LCD screen, the viewfinder, or the lens
to direct stmlight for long peliods of time may cause
malfimclions. Be careflll when placing the camera
near a window or outdoors.
• Do not aim at the sun Doing so might cause your
camcorder to malfimction. Take pictmes of the sun
only in low light conditions, such as at dusk.
Note on connecting other device
Before connecting your camcolder to other device
such as a VCR or a computer with a USB or i.LINK
cable, be sure to inselt the connector phlg in the proper
direction. If you inselt the connector phlg tbrcibly in
the wrong direction, the terminal may be damaged, or
this may cause a malfimction of your camcorder.
Notes on using this manual
• The images of the LCD screen and the viewfinder
used on this manual are captured using a digital still
camera, and thus may appear different from what
yoll see.
•The ilhlstrations used on this manual are based on
the model DCR-PC 109
Notes on using the camcorder
• Hold the camcorder putting your wrist through the
belt and yore fingers lightly on the finger rest
rest
• To ensure a good grip, fasten the Strap Belt as shown
in the following illustration. If the Strap Belt hangs
out too tar, tuck it in the hand pad.
• The Strap Belt can also be used as a wrist stlap
(p 142).
• When you are using the touch panel, place yore hand
on the back side of the LCD panel to support it.
Then, touch tile buttons displayed on the scleen
Touch the button on the LCD screen.
• You can change the language to be used for screen
display on your camcorder (p. 25).
• Be carefifl not to press buttons on the LCD fiame
accidentally when you open or close the LCD panel,
or when you adjust the angle of tile LCD panel.
• Do not hold the camcorder by the following pa_ts.
4