Soteria Systems AR4B User manual

1. Camera Overview
2. Get the App
Download the free Soteria app to get started.

3-1. Camera Setup
1. Connect the power adapter to the device, then plug into a power outlet.
2. Connect the RJ45 Ethernet cable to the device, then plug into the Wi-Fi AP router.
3. The camera will be ready for app setup when the blue power LED indicator begins to flash.
3-2. Camera Setup
Select AR4 / AR4B in the APP then follow the instructions shown.
★Camera setup via PoE
1. Connect the RJ45 cable to the PoE Switch.
2. The camera is ready for app setup when the blue power LED indicator begins to flash.
Caution: Do not use power transformers with PoE Setup. A CAT.5E UTP/PE RJ45 cable is
recommended.

4. App Setup
1. Please make sure that your smart phone is connected to the same Wi-Fi SSID network.
2. After selecting the camera model, you will be taken to the Internet setup page.
3. Select Auto Detection (Android)/Ethernet Installation (iPhone).
4. The AMID will appear on the next screen once your camera has been detected, tap to
complete the setup process.
Note: The AMID can be found on the sticker on the camera.
★Please be sure your device is running on the latest firmware.
5. App Setup Complete
Note: This camera is designed for easy DIY installation but if you need local assistance, please
visit www.SoteriaAI.com to locate a professional installer near you.

6. Camera Position
AR4 has a viewing angle of 110°. The optimal viewing distance is within 16 feet (5 meters) from the
camera.
1. When mounting the camera on the wall, please be sure the vertical angle does not exceed
120°.
2. When mounting the camera on the ceiling, please be sure the vertical angle does not exceed
110°.
The camera needs to be mounted at least 6.5 feet (2 meters) above the ground. Try to avoid
direct exposure to sunlight and rain.
7. Mount Your Camera
Use the L-shaped hex key (size: 2.5mm) to adjust the camera to the desired monitoring position,
then tighten the bolts to secure the camera angle.

•1st Axis to pan camera left and right.
•2nd Axis to tilt the camera up or down.
•3rd Axis to rotate the camera.
Note: Please avoid rotating the camera more than 360°.
•Camera position when mounted against the wall.
•Camera position when mounted on the ceiling.
8-1. Mount Camera on Wall
1. Place the drill template in the desired position on the wall.
2. Drill into the 3 cross marked holes.
3. Be sure to use the provided wall anchors to insert into the wall.
4. Position the camera over the holes, then fasten the mounting screw into the anchors.

8-2. Mount Camera on Wall
★LED Indicator
．Blue LED indicates power status.
．Solid Blue LED: Device is powered on.
．Flashing Blue LED:
1. (Before installation/after camera has been reset) Camera is in installation mode.
2. (After installation) Camera is being accessed remotely by a user.
★Factory Reset
1. Make sure your camera is powered on.
2. Press and hold the reset button for about 5 to 10 seconds. Reset is complete when the blue
power LED indicator begins to flash.
Please refer to the FAQ page for more information on how to share the viewer or
administrator rights to other smart phone devices.

★Need Help?
•To find troubleshooting tips or to get support, scan this QR code or
visit: www.soteriaai.com/support
•All devices come with a limited one-year warranty! Scan the QR code to take you to Soteria's
legal page: www.soteriaai.com/terms-of-service
•Or, if you need additional help, just contact us! E-mail: [e-mail] or Phone: 1-
888-316-1381 (toll-free)