Spark R&D T1 User manual

Nose
Tail
Nose
Tail
3. Flip Heel Rest upside down.
Insert locker from the rear end of
the Heel Rest, angled up slightly. Fit
Locker into groove in the boom of
Heel Rest. Locker should be flush
with the boom of the Heel Rest
when inserted properly.
Setup & User Guide
Setup Instrucons:
More info:
Required tools:
(Found in your Spark Tool)
#3 Phillips head screwdriver
T1 HEEL LOCKER
Compability:
Compable with Spark R&D T1 baseplates (Men’s & Women’s Arc and
Surge models) and Ibex crampons. Not compable with Spark R&D Tesla
baseplates (Magneto, AerBurner), the Burton Hitchhiker, Sabertooth
crampons, or pin mount baseplates (Blaze, Burner, Fuse, Ignion).
Warning:
The Heel Locker is intended to be used as a touring and climbing aid.
Not to be used for high speed downhill skiing. Heel Lockers are
releasable and may release unexpectedly, potenally leading to a loss of
control. The toe pivots of these bindings are non-releasable.
Spark R&D will not be held liable for product damage due to user error. Read all instrucons before beginning!
Call or email us with quesons: [phone] / [email protected]
More info at sparkrandd.com
Included parts:
2x T1 Heel Lockers
1. Set up your splitboard in ride mode.
2. Remove the 4 x M6-8mm flat head screws
from the T1 Heel Rests with the #3 Phillips
head screwdriver.
4. Flip Heel Rest right side up and reaach
to your splitboard. Repeat for other side.
5. Check that you can slide your rear
binding on and off of your board. Some
stances may not allow enough room for
the Heel Locker levers, which may require
changing your rear foot angle or
placement. Pung the Lockers in the
locked posion may also provide the
needed clearance.
Underside of Heel Rests and Lockers

Tail Nose
Tail Nose
Heel Lockers are designed to release in the event of a forward fall or
excessive weight over the nose of your board halves. Aer a release
you will have to slide the Locker into the unlocked posion before
locking again. If the Locker is bent up aer a fall, you can bend it back
with a pair of pliers.
Setup & User Guide
T1 HEEL LOCKER
To Lock:
1. Make sure Locker levers are in
the rearward unlocked posion.
Flip up baseplate climbing wires
if you were using them.
2. Step down onto the Heel Rest.
3. Push the levers forward
toward the nose of your board
halves, Locker will engage with
baseplate, and you’re locked in.
Note: Lockers can be used with
crampons, great for side
stepping.
To Unlock:
4. Simply pull the cord loop
unl Lockers are in the
back unlocked posion.
Before touring:
Pull both Lockers to the tail of the board to the unlocked posion.
Note: If you can’t push the Locker to the locked posion you may need
to clear snow off the top of the Heel Rest or the baseplate where it
contacts the heel rest. Your screws may also be over ghtened.
If you find that your Heel Locker is sliding out of posion during use,
ghten the screws to keep it in the proper posion.
Touring Instrucons: connued from front side
Call or email us with quesons: [phone] / [email protected]
More info at sparkrandd.com