SPORTSFIELD SPECIALTIES SG618RINT Quick start guide

1 of 6 02/01/2016
International Youth Soccer Goal with
Front Post Ground Sleeves Installation Notes
SG618RINT
Hardware Parts List:
-(4) 1/4-20 X 2.500" Long S.S. Hex Bolt
-(8) 1/4" SS Flat Washer
-(4) 1/4" SS Lock Washer
-(4) 1/4-20 SS Hex Nut
-(4) 3/8-16 X 1” Long serrated washer Hex Bolt
-(2) Aluminum Ground Sleeve Caps
Channels

2 of 6 02/01/2016
1. Start by laying out the ground sleeves according to the layout (Fig. 1). Excavate holes
for the footings and set the concrete forms. Exact footing requirements will vary based
on local building codes and site specific soils reports.
Figure 1
2. Center the ground sleeve in the form and secure it in a plumb and level position. The
top of the ground sleeve should be flush with the finish grade.
3. After unwrapping and laying out all parts. Begin by assembling the front top bar to the
end upright frames, verify all clips are facing out (Fig. 3).
Figure 3
4. Using (2) 3/8-16 x 1” hex bolts; attach the Top Bar to the inside of both ends the right
and left end frames (Fig. 4). Note: Do not tighten hardware until all bolts are in place.
Figure 4A Figure 4B
End Frames

3 of 6 02/01/2016
5. Lower the soccer frame into the ground sleeves as shown (Fig 6) Net clips should face
away from the field.
Figure 6
6. The net stays can be attached to the goal on each end using the ¼-20 x 2.50” long SS
hex bolt as shown (Fig. 7).
Figure 7

4 of 6 02/01/2016
Figure 8
7. With the goal frame now fully assembled, attach the net to the goal. The top corner of
the soccer goal is where the Crossbar meets the Upright. On either side, begin by
attaching the net to the clips along the goal. The net is attached by first pushing the outer
binding through the clip, then securing in the groove (Fig. 8). Move along the Crossbar
attaching the net to every clip. Next, work down both uprights and the back around the
Ground Bar.
- Standard Installation Complete –

5 of 6 02/01/2016
Soccer Goal Safety Tips
* Remove nets when goals are not in use.
* Verify structural integrity and check for secure connecting hardware before every use.
Replace damaged or missing parts and/or fasteners immediately.
* NEVER allow anyone to climb on the net or goal framework.
* Ensure safety/warning labels are clearly visible (placed under the crossbar and on the
sides of the front-posts at eye level).
* Fully disassemble goals for seasonal storage.
* Exercise extreme caution and provide adequate manpower when moving goals. Only
authorized and properly trained personnel should move soccer goals.

6 of 6 02/01/2016
REPLACEMENT PARTS
Contact Sportsfield Specialties Customer Service at 1-888-975-3343 for replacement
hardware.
Sportsfield Specialties, Inc.
P.O. Box 231
41155 State Highway 10
Delhi, N.Y. 13753
Phone: [phone]
Fax: [phone]
www.sportsfieldspecialties.com