ST-Lab A-360 User manual

PCIe SATA II 300 Card 1 channel
User Manual
Ver. 2.00
All brand names and trademarks are properties of their
Respective owners.
Oct/07 1 MN

Features and Benefits
Silicon Image SiI 3531 chipset
Compliant with PCI Express Base Specification 1.0a
Compliant with Serial ATA 1.0a specification with support for
full complement of SATA II optional features
PCI Express 1-lane (x1) SATA II adapter works with PCI Express
slots with different lane width
Installs in any available PCI Express slot and support data
transfer rates up to 3.0Gbps (300MBps)
Supports Native Command Queuing (NCQ), Non-zero offsets
NCQ, and Out-of-order date delivery NCQ
Independent command fetch, scatter / gather, and command
execution
Hot-swapping feature allows you to attach/detach SATA device
without first powering your computer off
Supports Windows7/8.1/10(32.64)
Connectors
1 x internal SATA connector
1 x external eSATA connector
Oct/07 2 MN

System Requirements
Windows7/8.1/10(32.64)
PCI Express-enabled system with an available PCI Express slot
Package Contents
1 x PCIe SATA II 300 Card
1 x Driver CD
1 x User Manual
Note: Contents may vary depending on country/market.
Oct/07 3 MN

Hardware Description
C (Jumper Settings)
JP Description Active Port
J1-J4 1-2 close Enable SATA Connector A
2-3 close Enable SATA Connector B
Oct/07 4 MN

Note: There are two SATA ports in PCIe SATA II 300 Card. We name
these ports A and B. Port A is external SATA port and B is internal
SATA port. Only one of them will work but not both at the same time.
Please set which port to work by jumper setting. By default, Port B is
working.
Hardware Installation
1. Turn Off the power to your computer and any other connected
peripheral devices.
2. Unplug the power cord from the back of the computer.
3. Remove your computer’s cover.
4. Remove the slot bracket from an available PCI Express slot.
5. To install the card, carefully align the card’s bus connector with
the selected PCI Express slot on the motherboard. Push the board
down firmly, but gently, until it is well seated.
6. Replace the slot bracket’s holding screw to secure the card.
Oct/07 5MN

Driver Installation
For Windows7/8.1/10(32.64)
1. At the Found New Hardware Wizard window pop-up, please
select Locate and install driver software (recommended) to
start the installation.
2. Please insert the driver CD into your CD-ROM Drive.
3. Click on Close to complete the driver installation.
Oct/07 6MN