Stingray ALVA Air ACS102 COOL CUBE User manual

• Place Cool Cube on a raised surface such as a table, desk or counter
top. This is the best way to cool your personal space fast.
• Let the lter absorb water for at least 3 minutes after lling the tank
before use.
• Try to stay nearby the cool cube. You’ll feel the most benet when
sitting directly in front of it.
• The Cool Cube will run for approximately 12 hours on a single tank
of water on low fan speed. Even if the water tank is empty, the lter
is still damp and the cooler will still cool. Do not move the cool cube
while there is water inside.
USEFUL TIPS:
1. Set the Cool Cube on a at surface such as a table or desk (see Fig 1).
Attach power adapter to power adapter Port, and plug power
adapter into wall outlet. Note: Please remove the foam infront of the
lter before use.
2. Use the lter draw tab to pull out the lter drawer and remove lter.
(see Fig 2)
3. For best results, lightly pre-soak under cold running water. For even
more cooling power, place the wet lter in the freezer until frozen.
Place back in drawer when done. (see Fig 3).
4. Open water tank door and ll to Max ll indicator. Close water
tank door when done. (see Fig 4). We recommend using a jug or
measuring cup. DO NOT OVERFILL.
PLEASE NOTE: Use built-in cord guide along the back to keep cord away from fan.
1. Press the button to turn the Cool Cube one - it will default to
high speed mode. (see Fig 5).
• 1st press: Power on, High
• 2nd press: Medium
• 3rd press: Low
• 4th press: Power o
PLEASE NOTE: Cool Cube will run up to 8 hours on high, 10 hours on medium, 12 hours on low.
2. Use the Air Direction Tab to adjust airow up/down to your preference.
(see Fig 6).
Fig 1 Fig 3 Fig 4Fig 2
Fig 5 Fig 7 Fig 8Fig 6
SETUP:
USAGE:
USAGE (CONT.):
WARNINGS:
3. Choose dierent colour lights by pressing button. (see Fig 7).
• 1st press to change: Press the button to choose the dierent light colours
according to the dierent scenes and time.
• 2nd press: Light o.
4. To power o, press the button until fan turns o (one press after low
speed), and mode indicator lights are no longer lit. (see Fig 8).
IMPORTANT: If you do not plan to use the Cool Cube for an extended period of time, it is
recommended that you empty the water tank and let unit/lter dry before storing. This will avoid
mould and unpleasant smells, and prolong life of Cool Cube and lter.
• Do not carry Cool Cube when lled with water. Some water may remain in the
unit even if tank is empty.
• Use only clean water. If needed, use distilled water.
• Please read and follow regular maintenance as recommended in
“Maintenance”section of this guide.
• Cool Cube works best in non-polluted areas. Large dust/dirt particles may
reduce lifetime of unit.
• We recommend to only use in dry locations. If using in a moist area or
environment, take care not to get water on external areas of the product.
• If a leak or spill occurs on the surface of device, unplug Cool Cube and let it
dry for 24 hours. Then, use as normal.
• Do not place in direct sunlight for extended periods of time.
• Only use the original power cord supplied in package.
• Do not touch the power supply or power cord with wet hands.
• Unplug Cool Cube when cleaning, removing/replacing lter, or moving the
device.
• For best results, place Cool Cube on a higher surface like a table or countertop.
• Do not place near a heater or any electrical equipment.
• Do not place the device in passageways or high trac areas where there is a
possibility of tripping or knocking it over.
• Do not allow any foreign objects inside Cool Cube.
• Do not place items on top of Cool Cube.
• Do not block the front and back grills of the device.
• Do not turn the device upside down.
• Do not submerge the Cool Cube under water or other liquids.
• Do not place Cool Cube near open ames or re sources.
• People with limited physical, visual or mental abilities or lacking proper
experience and/or knowledge should never us the device without supervision
of those responsible for their safety or those capable of assistance in using the
device.
• The device can be switched o completely only when disconnected from the
power supply.
• The manufacturer does not bear any responsibility for any damage from
failure to comply with this product guide.
• A replaceable water lter is designed specically for this product.
MAINTENANCE:
We recommend weekly cleaning of your Cool Cube and lter to keep it in best
working condition and replacing the lter every 3-6 months.
Dishwasher: Place lter in the top-rack of your dishwasher and run cycle
normally. Remove and let air dry. (see Fig 9).
Hand Wash: Hand wash gently with warm water and soap. Shake out excess
water and let air dry. (see Fig 10).
Microwave: Between washes, sanitize your lter by placing in microwave on
high for 30 seconds at a time, up to 2 minutes. Let stand until cool. (see Fig 11).
IMPORTANT: If you see mould on the lter or notice a musty smell, stop and clean the lter before
further use. Fully submerge the lter in a pot or bowl lled with equal parts clean water and
white vinegar - allow to soak for 45-60 minutes. Rinse with warm water, wring out and let dry.
Unit Cleaning
• To prepare for cleaning, run Cool Cube until all water has emptied
from the water tank, or hold Cool Cube over a sink and carefully drain out to
avoid splashing or spilling. (see Fig 12).
• Remove lter tray from Cool Cube. Using warm, soapy water, wipe lter tray
and grill, then rinse o until clean. Let air dry. (see Fig 13).
• If you notice water tank is dirty, use a small bendable brush (i.e. toothbrush,
bottle brush, etc) and carefully clean the inside of the tank. Rinse with warm
water.
COOL CUBE
PERSONAL EVAPORATIVE AIR COOLER
ACS102
Fig 9 Fig 10 Fig 11
OR
Fig 12 Fig 13
2 3 4
Life’s Cool

1. PRE-SOAK FILTER: Place your lter under cold running water until
wet. (see Fig 14).
TIP: For greater cooling, place a wet lter in the freezer until frozen.
2. FILL WITH WATER JUG: Place on at surface and ll tank from a water
jug or cup. (see Fig 15).
3. SET AIR FLOW: Point towards you and adjust the grill to direct air
ow. (see Fig 16).
4. FILTER CLEANING: We recommend regular cleaning of your lter. See
Product Guides or Care and Cleaning label on the lter for instructions.
(see Fig 17).
PLEASE NOTE: You may notice some condensation forming on the front grill. This is normal.
FOR BEST RESULTS
COOL CUBE
PERSONAL EVAPORATIVE AIR COOLER
ACS102
NOTES:
Information on the disposal for Waste Electrical & Electrical Equipment (WEEE)
This symbol on the product and accompanying documents means that used
electrical and electronic products should not be mixed with general household
waste.
• Do not submerge the cooler under water or other liquids.
• Do not place cooler near open ames or re sources.
•People with limited physical, visual or mental abilities or lacking proper
experience and/or knowledge should never use the device without
supervision of those responsible for their safety or those capable of assistance
in using the device.
• The device can be switched o completely only when disconnected from the
power supply.
• The manufacturer does not bear any responsibility for any damage from failure
to comply with this product guide.
• A replaceable water lter is designed specically for this product. If your
cartridge has been broken or damaged, you can purchase a replacement.
CONTACT DETAILS:
A division of Stingray Accessory Manufacturers (Pty) Ltd
P.O. Box 30014, Tokai, 7966
[phone] | [e-mail] | www.alva.co.za
TOLL FREE NUMBER: 086 100 ALVA (2582)
Manufactured for and Distributed by:
This is an ALVA product. This product is not available as a private label variant.
FOR HOUSEHOLD USE ONLY
Alvaelectricsa
CONTENTS:
Cube • Filter •USB cable
Air
Direction
Tab
Water tank
Door
Fan Speed
Indicator
Lights
Power/
Fan Speed
Button Power
Port Light On/
O Button
USB CABLE
Filter Drawer
Tab
PULL TO
ACCESS FILTER
Fig 14
Fig 16 Fig 17
Fig 15
15 6
Life’s Cool
Life’s Cool