straightcurve 240mm Rigidline User manual

www.gardenedging.co.nz All fixings and accessories not to scale. Accessory corners, joining
sleeves and fix pegs available in weathering and galvanised steel finish.
Specifications
240mm Rigidline™
LENGTH 2160mm | TOP THICKNESS 8mm
FINISHES
Weathering Steel
Galvanised Steel
Steel plate thickness 2mm
SOLD AS SET INCLUDING
1 x Joining set (2 x wedge, 2 x slider,1 x joint bracket)
5 x galvanised spikes, 300mm long
2 x bracing ribs (attached to edge)
ADDITIONAL ACCESSORIES
REQUIRED
Small anchor post (2 x Tek screws 12G x 16mm)
OPTIONAL
Corner piece (arm lengths: 255mm)
Joining sleeve (6 x Tek screws 12G x 16mm)
Universal bracing set (turnbuckle/chain/stake)

www.gardenedging.co.nz  
A02.V3
Installation guide
240mm Rigidline™
Scan code for installation video
or follow the link below
www.straightcurve.info/029
Scan me for
installaon video!
VIEW VIDEO
STEP 1 - JOIN
4B - BRACE
STEP 3 - PEG STEP 4A - STAKE (OR)STEP 2 - POSITION
PRE-MADE CORNER* MAKE CORNER - NOTCH/SCORE WITH GRINDER
PREPARATIONS
Mark line and level or trench as required ready for install.
CORNERS
Pre-made corners* are available for purchase, these include
the standard joining set. These can be opened or closed
further with forceful bending to achieve different angle
corners. You can also choose to make your own. To do this
score a line down the back of the edge and create a sufficient
opening (5-7mm) in the folded lip at the top and cut out part
of the foot at the bottom with your angle grinder to allow
space for bending. Bend strongly by hand; using a block of
wood close to the fold to form bend against.
STAKING THE EDGE
Anchor posts are driven in as a stake behind the edge
adjacent to a bracing rib, which is then screwed onto with
screws. It is recommended to use two of these per edge.
HARD SURFACE FIXING
If you need to secure the edge to hard surfaces, the universal
bracing set can be used. To secure to a concrete surface
remove stake and use bolt down method instead (purchase
bolts separately).
JOINING SLEEVES
Shortening a length is sometimes a requirement. The Joining
sleeve is used to connect the two edges when this occurs.
These are fixed to the panel front with screws through the
guide holes in the sleeve.
TIP
The pre-attached bracing ribs can be moved. Knock
sideways at top to dislodge then pop out from bottom and
do opposite to re insert them where needed.