8
To create a room, proceed as follows :
1. Tap on the small circle “Room #” on the left part the Controller Screen of your SwiidCam+™(below
the camera icon in the big circle) so that it lights up and a scrolling list of rooms appears on the
right side of the screen (Rooms Side Screen).
2.Then tap on the small circled “+” in the upper right-hand corner above the existing room list (may
only contain “unassigned” if no room have yet been added)
3.Enter a room name of your choice and submit
You can then add devices to this room or remove them or move them to other rooms by tapping on
the room rectangle on the list of rooms (Step1 above) and then tapping on the small circle “” towards
the bottom of the right side of the screen and following the on-screen instructions.
Non-Z-Wave : When tapping on the room rectangle on the list of rooms (Step1 above), you will get
a list of all the Z-Wave®devices in the room, as well as the IP camera which has been attributed to
that room. It is possible to assign another camera to this room (provided it has been previously added
to the system) by tapping on the camera name and following the on-screen instructions.
All the rooms created (i.e. other than the “unassigned room”) can be deleted by following the same
procedure as the one described above except that one must tap the small circled “-“ instead of the
“+” and following the on-screen instructions.
Overall, your SwiidCam+™is capable of handling up to 40 rooms and a maximum of 60 Z-Wave®
devices (in 1-40 rooms).
C- SCENES
In Z-Wave®, scenes are software routines which make it possible to send different commands to
different devices, making several different things happen at the same time or in sequence over time
or not. Such scenes are subject to trigger conditions, either voluntary like pressing on a button, or
automatic like the change of status of one or more devices and timing.
To add and programme a scene on your SwiidCam+™, proceed as follows :
1. Tap on the small circle “Scene #” on the left part the Controller Screen of your SwiidCam+™(right
side below the camera icon in the big circle) so that it lights up. The right hand side of the screen
will change to the Scene Side Screen.
2. Then tap on the big right-hand circle with a “+” which should be entitled “Add a scene” (if this is the
first scene to be programmed) or on the small circled “+” in the upper right-hand corner above the
existing scene list, enter a scene name in the pop-up window and confirm by tapping "OK".
3. The screen will then show you an input request for the conditions (“IF” and “WHEN”) and the actions
(“THEN”). Follow the on-screen instructions to fill in the various conditions/actions instructions and
submit the scene for implementation.
IF conditions apply to the change of status of one or several Z-Wave®devices, of room conditions or
conditions reported by any IP cameras which are in the network of your SwiidCam+™. These
conditions can be alternative or cumulative : toggle by tapping on the circled “+” or “or” between
condition icons. Each scene can accept up to six IF conditions
WHEN conditions contain the time period or periods during which the scene will be active.
THEN actions can include changes to the status of one or more actionable devices, sending out of
alarm push notifications (see below), or recording of video and/or sound.
D- HOME/AWAY/SLEEP
By tapping on the small circle “Home” on the left part the Controller Screen of your SwiidCam+™
(immediately below the camera icon in the big circle), the right-hand side of the screen will change to
