Sycamore VEGA SY8975 BN User manual

Installaon instrucons : SY8975 VEGA Round 4 Light Plinth Kit BN/NW
SycamoreLED.com
LS26 8XT
Technical helpline : 0113 2866686
*Please email [email protected] to register your product
1) Please read these instrucons carefully before commencing any work
2) This product must be installed by a qualied electrician in accordance with the current IEE wiring regulaons
3) To prevent electrocuon switch the power o at the mains supply before installing or maintaining this ng
4) Ensure others cannot restore the electrical supply without your knowledge
5) The PSU must be rated 12VDC and be compable with the pre-wired connector system of this product
6) Never exceed the waage stated
IMPORTANT—Please read prior to installaon
CARE IN USE
GENERAL
Thank you for purchasing this SycamoreLED.com product. Please make sure instrucons are followed carefully prior to and during installaon and
product is not altered, otherwise warranty may not be valid. For technical support or warranty informaon please visit www.sycamoreLED.com, or call
our dedicated technical helpline [phone].
Item Rated voltage/V Rated power/W LED numbers ProteconIP Rang
SY8975 12v DC 4×1W 1/LT CLASS Ⅲ20
PRE—INSTALLATION
1) Prepare all the parts and tools required for the installaon
2) Turn o power before installaon.
3) If the housing or glass diuser is broken or damaged do not use it.
1) For recessed cut the diameter hole 28MM
on the surface to which the light is being
installed (without surface spacer part).
2) Put the wire through the hole
3) Connect the power with 12VDC driver &
push the lamp into hole.
4) Ensure the body of the lamp is securely
xed on the face of installaon, then
restore the power and check operaon.
5) For surface mounng or to install within a
wall, use the supplied surface spacer and
follow instrucons 2-4 above.
Please note that the LED driver is IP20
1) Please note this ng has non replaceable parts
2) Always switch o or disconnect from the mains when cleaning the product.
3) We recommend cleaning with a so dry cloth. Do not use scourers, abrasives or chemical cleaners.
INSTALLATION with Diagram

SY8975