TabLines TSG User manual

EN
TabLines TSG Tablet Protective Case Oak
Assembly instructions
Be sure to read the assembly instructions before assembly - installation - commissioning!
This will protect you and prevent damage to your product.
Your TabLines dealer/specialist partner
Subject to change without notice
TabLines
Am Marienhof 8
22880 Wedel
Germany
E-Mail: [e-mail]
Web: www.tablines.de
Tel.: [phone] / 90387 - 0
Fax: [phone] / 90387 - 11
Contact us
TabLines TSG Tablet Protective Case Oak
Assembly#instructions
TabLines TNT001 Wall-mounted USB power supply unit
To mount your tablet in the TSG protective housing on
the wall, we recommend the TabLines TNT001 power
supply unit for permanent power supply.
Due to its compact form, the TabLines TNT001 can be
integrated into conventional flush-mounted switch
boxes (System 55). The two wires of the power supply
unit (see fig. 7) can be easily connected to the power
source.
Please note that the output power of the TabLines
TNT001 power supply unit is 1A.
Fig. 7: Connect tablet with optional power supply unit
3. Optional accessories

EN
Assembly Instructions TabLines TSG Tablet Protective Case Oak - Version no. 2021-07
EN
Versionsnr. 2016-08 - Montageanleitung TabLines TWE Tablet WandeinbauVersion no. 2021-07 - Assembly Instructions TabLines TSG Tablet Protective Case Oak
1. Scope of delivery
Included in delivery:
1x Frame
1x Case
1x Mounting plate
4x Screws
1
2
3
4
Fig. 1: Removing the mounting plate
2.2 Loosen screws
Loosen all four screws on the back of the enclosure.
Attention: The screws are needed again in step 2.5 to
fix the enclosure..
2.1 Remove the mounting plate
Slide the mounting plate downwards and lift off the
plate.
2. Inserting the tablet
Fig. 2: Loosen the screws on the housing
1
2
3
4
Fig. 3: Remove the housing from the frame
Fig. 4: Inserting the tablet
2.4 Inserting the tablet
Place the tablet between the insert strips as shown in
Fig. 4 (the insert strips are supplied already glued in
place).
Note that the home button of the tablet is at the
bottom.
2.5 Close the protective housing
Place the case back on the back of the frame and
tighten all four screws.
Optionally, you can attach a charging cable to the
tablet and pull it through the recess provided on the
back.
2.3 Remove the housing
Remove the housing from the frame.
Caution: The housing is needed again in step 2.5 to
close the protective housing.
2.6 Attach the mounting plate
If desired, the mounting plate can now be attached to
a bracket with a VESA standard of 100x100 mm, which
can be purchased separately.
Then slide the enclosure onto the mounting plate from
above.
If no further fastening is desired, this step is omitted.
Fig. 5: Close housing
Fig. 6: Attach the fastening plate