Tagbox Tag360-SBM User manual

Tag360-SBM
Tagbox Copyright 2019 [e-mail]
1
[e-mail]
Tag360-SBM is a Bluetooth Low Energy (BLE) “Smart Bike Module” intended as an add on
attachment to vehicles, thus allowing the vehicles to be immobilised using associated Keyfob
device, TAG360-KF, or via a mobile app.
Tag360-SBM uses Bluetooth Low Energy (BLE) to get mobilize or immobilise commands from
TAG360-KF, or from mobile app. These commands are passed on to vehicle’s engine control
unit (ECU) via a digital bus, e.g. CAN. Tag360-SBM is powered by vehicle’s battery. A backup
battery of 12V is provisioned within the unit.
Features
•BLE 4.2/5.0
•Secured via Authentication and
(optional) 128b AES encryption
Applications
•Mobilise/Immobilise vehicle
•Enhanced vehicle security
•Last parked location

Tag360-SBM
Tagbox Copyright 2019 [e-mail]
2
[e-mail]
Specifications
Electrical and Radio Specifications
Radio
Bluetooth Low Energy, BLE 5.0
Power
Vehicle 12V battery
Interface
Custom 1-wire interface to TCI unit
Mechanical Specifications
Dimensions
66.5mm*56mm*26mm
Block Diagram
GND
12V

Tag360-SBM
Tagbox Copyright 2019 [e-mail]
3
[e-mail]
Connector Pinout
PIN #
DESCRIPTION
1
GROUND
2
NC
3
BATTERY
4
NC
5
TCI
6
IGNITION
Installation Instructions
Step1:
The SBM unit needs to be mounted on vehicle through its special clamp, as shown in drawing below.
The clamp inserts into rubber boot, thus securing the SBM unit to the vehicle.

Tag360-SBM
Tagbox Copyright 2019 [e-mail]
4
[e-mail]
Step2:
Connect the SBI connector output to TCI Unit. The SBM connector output is a 6 pole Besmak
connector-Male, which connects with corresponding 6-pole female connector of TCI unit.
Step 3:
The SBM unit is supplied with a pre-paired Tag360-K1 Keyfob unit. The unit has identification QR
code on one side, while the functional LED and button press are provided on the back

Tag360-SBM
Tagbox Copyright 2019 [e-mail]
5
[e-mail]
After installation of SBM unit, the vehicle can be mobilised or immobilised via the keyfob unit.
Step 3.1: Turning on the vehicle
a. Keyfob unit should be in Bluetooth range of the vehicle. It is recommended that the keyfob
should be within 5 meters from the vehicle
b. Insert physical key into the vehicle and turn the key ON
c. Press Keyfob button for 1 second and wait for LED to glow. Once the green LED glows, the
vehicle is mobilised
d. Kickstart or press the ON button on vehicle to start the two wheeler
Step 3.2: Turning OFF the vehicle
e. As soon as the vehicle is turned off through the physical key, the vehicle is immobilised
automatically
f. This can be further confirmed by button press. Once in vehicle Bluetooth range
(recommended range is within 5 meters of vehicle), press the Keyfob button and wait for
LED to glow. Once the LED glows red, vehicle is immobilised
If the key is already in the vehicle and in ON state, the button press is ignored. However, the SBM
records the last command, and implements it as soon as key is turned OFF.

Tag360-SBM
Tagbox Copyright 2019 [e-mail]
6
[e-mail]
FCC WARNING NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a vehicular installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to another radio equipment or device, which can be determined by turning this
equipment off through a plug-out, the user is encouraged to try to correct the interference by one or
more of the following measures:
oRelocate the vehicle with the installed unit
oIncrease the separation between the equipment and impacted unit
oConsult the authorised dealer or an experienced technician for help
This equipment must be installed and operated with a separation distance of at least 20 cm from all
persons.
Regulatory Information
TAG360-SBM comply with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) these devices may not cause harmful interference, and (2) these devices must accept
any interference received, including interference that may cause undesired operation.
Co-Location Warning Statement: These devices and their antennas must not be co-located or
operating in conjunction with any other antenna or transmitter.