TeeJet Technologies RX375P User manual
www.teejet.com
INSTALLATION
RX375P RECEIVER
INSTALLATION AND SPECIFICATIONS
Mounting Considerations
1. When mounting the RX375P Receiver, a space of
at least 6 inches (15 cm) between the receiver and
any bend in the cable is required. Any length shorter
than 6 inches puts undue stress on the cable and the
enclosure for the RX375P.
2. The Receiver should not be mounted where water can
pool around it. The receiver housing is designed to
withstand rain and splashing, but not submersion in
liquids for sustained periods of time.
3. Mount the receiver above all other metal objects to
avoid multipath. Satellite signals received by the GPS
receiver by a reection from an object can decrease
positioning accuracy. For example, roof racks, large
headlight enclosures, etc., can cause multipath that
may result in a jump in GPS position.
5.7 inches / 14.5 cm
4.1 inches / 10.4 cm
LED Status Indicator
Red - power is ON
Amber - GPS lock
Green - DGPS solution
Deutsch connector
Port A: 4800 GGA 1Hz
VTG 1Hz
Port B: 19200 GGA 5Hz
VTG 1Hz
RX375P Receiver Installation
1. Make sure the surface of the vehicle is clean, dry, and free of dust particles.
2. To magnetically mount the RX375P, attach the black magnetic base unit to
the underside of the receiver and mount it to a metal surface.
3. To mount the receiver to a berglass surface, remove the adhesive pad
and attach it to the vehicle. Adhere the metal disk to the other side of the
adhesive pad, holding rmly in place for 10 seconds to ensure a secure
connection. Magnetically mount the RX375P to the disk.
Mount antenna at a minimum of 6 inches (15 cm) before
applying a bend to the cable
98-01479-ENUS R0 English-US
© TeeJet Technologies 2013
TeeJet Technologies
1801 Business Park Drive
Springeld, Illinois 62703 USA
www.teejet.com
INSTALLATION
SPECIFICATIONS
Calibration Numbers
TeeJet Technologies Typical Speed
Products Calibration Number
Radion .......................................................................................................... 8590
IC18.............................................................................................................. 8590
Legacy PCM/DCM........................................................................................ 1064
TASC/ARC...................................................................................... 1064
TeeJet 844/854/834.............................................. 859 (With RAD “ON”)
LH 70 Series................................................................................... 8590
LH 85.............................................................................................. 8590
LH 500 Series................................................................................. 8590
LH 5000.......................................................................................... 8590
LH 6000.......................................................................................... 8590
LH IC 24 ....................................................8590 or 1.064 cm per pulse*
LH IC 34 ......................................................................................... 8590
* Depending on the application can operate in Autonomous Mode
Electrical Connection Specications
Deustch Connector’s Pin-outs
1. Manual mark in
2. TxB
3. RxB
4. CAN high
5. Signal Ground
6. TxA
7. One PPS
8. RxA
9. CAN low
10.Power in (12V)
11. Power Ground
12.Speed out
GPS Sensor Specications
Receiver Type.....................L1, C/A code with carrier phase smoothing
...(Patented COAST technology during differential signal outage)
Channels ................................................... 12-channel, parallel tracking
................................... (10-channel when tracking SBAS) (WAAS)
Update Rate .............................................................1 - 20 Hz Positions
Horizontal Accuracy............ < 2.0 ft / 60 cm 95% condence (DGPS)¹ *
............. < 8.2 ft / 2.5 m 95% condence (Autonomous, no SA)² **
Differential Options........... SBAS (WAAS, EGNOS, MSAS), e-Dif, L-Dif
SBAS (WAAS) Tracking............................... 2-channel, parallel tracking
Start Up Time.........................Cold Start: < 60 s (no almanac and RTC)
.........................................Warm Start: < 30 s (almanac and RTC)
................... Hot Start: < 10 s typical (almanac, RTC and position)
Satellite Reaquisition...................................................................... < 1 s
* Depends on multipath environment, number of satellites in view, satellite
geometry, baseline length (for local services), and ionospheric activity.
** Depends on multipath environment, number of satellites in view, satellite
geometry, and Ionospheric activity.
Communication Specications
Serial Ports............................................................ 2 Full Duplex RS232
CAN.................................................................... NMEA 2000 broadcast
Pulse Output.................... 1 PPS (CMOS, active low, falling edge sync)
Baud Rates...................................................................... 4800 - 115200
Differential Correction I/O Protocol.......................... RTCM SC-104 v2.x
Data I/O Protocol..................NMEA 0183, SLX Binary and NMEA 2000
Ground Speed Output
Range: ...............................................0.5 -> 200 mph / 0.8 -> 322 km/h
Signal: .................................................................................... Pulse Out
Frequency Conversion: ..........................................................94 Hz/m/s
.................................................... (28.65 Pulse Per Foot Traveled)
Event Mark Output................................................... CMOS, Active Low,
..................................... Falling Edge Sync, 10 K-ohm, 10pF Load
Part Numbers
Kits and Components
45-05495 Cable, RX370P or RX375P Speed Only
45-05338 Cable, GPS Data w/12 position Deutsch
45-05496 Cable, RX370P or RX375P DB9, Speed, Power
45-05340 Cable, Deutsch to DB9
45-05350 Cable, Com 1 & 2 w/Power In
78-50203 Receiver, GPS RX375P SBAS
Environmental Specications
Operating Temperature.........................-22°F - +158°F / -30°C - +70°C
Storage Temperature............................-40°F - +185°F / -40°C - +85°C
Humidity...............................................................95% Non-Condensing
Enclosure.......................................................Waterproof and Dustproof
Compliance...............................................................................FCC, CE
Shock................................................EP455 Section 5.14.1 Operational
Vibration ................................................EP455 Section 5.15.1 Random
EMI Certication ...................CE (ISO 14982 Emissions and Immunity),
.................................................................................. FCC Part 15,
..................................................................... Subpart B, CISPR 22
Power Specications
Input Voltage......................................................................... 7 - 32 VDC
Power Consumption .......................................< 3 W @ 12VDC (typical)
Current Consumption .................................. 249 mA @ 12VDC (typical)
Power Connector..................Cable Mount and Environmentally Sealed
Physical Specications
Height .............................................................................4.1 in / 10.4 cm
Width ..............................................................................5.7 in / 14.5 cm
Weight ......................................................................... <19.7 oz /<558 g
Mounting Options ..........................................................Magnetic Mount
........Fixed Mount (5/8 inch or no. 8-32 screws); 1" mounting hole
Other TeeJet Technologies Receiver manuals
