Testrite Visual Charisma SEG Expo Stand XP Series User manual

Page 1 of 2Version: 2
1. Attach the upright/s to the base using the screws provided. For XPS72 ONLY, the frame
attaches directly to the base
2. Assemble the frame, as shown on next page.
3. Attach the frame to the upright/s using the screws provided. For XPS72 ONLY, attach the
frame directly to the base using the two screws provided, as shown below.
4. Install the graphic, as shown on next page.
Charisma SEG Expo Stand™ - XP Series
XPLF36 XPS36 XPS72
1. 1. 3.
1.
3.
2.
4. 4. 4.
3.
2.
2.
1.
3.
3. Frames
with uprights

Page 2 of 2Version: 2
Charisma SEG Expo Stand™ - XP Series
2
For proper assembly, it is important to notice that two frame-sides have brackets premounted, and two sides do not.
1. Using the screws provided, attach the two frame-sides without bracket to the rst frame side with brackets.
2. Connect the second frame-side with brackets to the assembled portion of the frame.
3. To install the graphic, take the corner with the pull tag on it and press about 6”-10” of silicone into the frame channel
corner A. Repeat for the opposite corner B. Repeat for the next corner C. Lastly, repeat for the nal corner D.
4. After all corners are pressed in, press the silicone into the frame channel at the mid-points on all four sides.
5. Press silicone into frame evenly between the corners and midpoints.
This prevents the graphic from bunching up or stretching too much and will ensure a smooth and tight t.
6. To remove the graphic from the frame, simply pull up on the pull tag.
7. Repeat graphic installation for reverse side (not shown).
2.
3. 4.
1.
1.
pull tag
pull tag
A
B
C
D
5. 6.
Single Brackets
for XPLF, XPS28,
XPS36
Double Brackets
for XPS72
Double Brackets
for XPS72