Toa CD-2011R AS User manual
CD PLAYER CD-2011R AS
INSTRUCTION MANUAL
WARNING
CAUTION
WARNING
Indicates a potentially hazardous situation which, if mishandled, could
result in death or serious personal injury.
Indicates a potentially hazardous situation which, if mishandled, could
result in moderate or minor personal injury, and/or property damage.
CAUTION
TOA Corporation
Thank you for purchasing TOAs CD Player
Please carefully follow the instructions in this manual to ensure long, trouble-free use of your equipment.
1. SAFETY PRECAUTIONS
Be sure to read the instructions in this section carefully before use.
Make sure to observe the instructions in this manual as the conventions of safety symbols and messages
regarded as very important precautions are included.
We also recommend you keep this instruction manual handy for future reference.
Safety symbol and Message Conventions
Safety symbol and messages described below are used in this manual to prevent bodily injury and property
damage which could result from mishandling. Before operating your product, read this manual first and
understand the safety symbols and messages so you are thoroughly aware of the potential safety hazards.
When Installing the unit
Do not expose the unit to rain or an
environment where it may be splashed by water or
other liquids, as doing so may result in fire or
electric shock.
Use the unit only with the voltage specified on the
unit. Using a voltage higher than that which is
specified may result in fire or electric shock.
Do not cut, klink, otherwise damage nor modify the
power supply cord. In addition, avoid using the
power cord in close proximity to heaters, and never
place heavy objects -- including the unit itself -- on
the power cord, as doing so may result in fire or
electric shock.
Avoid installing or mounting the unit in unstable
locations, such as on a rickety table or slanted
surface. Doing so may result in the unit falling down
and causing personal injury and / or property
damage.
To prevent lightning strikes, install the unit at
least five meters away from the lightning rod, and
yet within the protective range (angle of 45°) the
lightning conductor. Lightning strikes may cause
the fire, electric shock or personal injury.
When Installing the unit
Never plug in nor remove the power supply plug
with wet hands, as doing so may cause electric
shock.
When unplugging the power supply cord, be sure to
grasp the power supply plug; never pull on the cord
itself. Operating the unit with a damaged power
supply cord may cause a fire or electric shock.
When moving the unit, be sure to remove its power
supply cord from the wall outlet. Moving the unit
with the power cord connected to the outlet
may cause damage to the power cord, resulting in
fire or electric shock. When removing the power
cord, be sure to hold its plug to pull.
Avoid installing the unit in humid or dusty locations,
in locations exposed to the direct sunlight, near the
heaters, or in locations generating sooty smoke or
steam as doing otherwise may result in fire or
electric shock.
2. GENERAL DESCRIPTION
The CD-2011R AS is a CD player and Digital
processing FM radio tuner capable of storing up to
30 receiving channels, each of which can be recalled
by one - touch operation. CD with mechanic and
electronic anti - shock, CD, CD-R, CD-R/W, MP3,
USB and Card MP3 playable. The unit can be
mounted on an EIA equipment rack.
42
250
3
CD/USB/SD
430 26
44
6
12
55
155.9
51.8 19.4
4. DIMENSIONAL DIAGRAM
5. SPECIFICATIONS
Power Source
Power Consumption
CD Frequency Response
Audio Input
20 - 20,000 Hz, ±3 dB
15 W
220 ~ 240V AC, 50/60 Hz
Tuner Receiving Frequency 87.5 -108 MHz ( 50 kHz step )
Audio Output
Channels of Memory Tuner 30 Channels in total for FM broadcasts
Operating Temperature 0°C to 40°C
Finish Front Panel : Steel Plate, Color Black
Dimensions 482 (W) X 44 (H) X 250 (D) in mm
Weight 3.6 kg ( without accessories )
533-10-001-10
URL: http:\\www.toa.com.sg
Unit : mm
REAR VIEW
TOP VIEW
FRONT VIEW
SIDE VIEW
REMOTE CONTROL
Note : The design and specifications are subject to change without notice for improvement.
Case : Steel Plate, Color Black
Accessories AC Power cord
FM radio Antenna
Indicators CD Player : LED, Tuner FM : LED
FM 75 ohms unbalanced antenna terminals,
USB port for memory stick ( support up to 32GB ),
SD/MMC card slot ( support up to 32GB ).
RCA audio output for FM L and R channels, RCA audio output for CD
L and R channels, RCA audio output for PRIORITY L and R channels.
Remote Control
CD/USB/SD
1 2 3 4 16 10 9 8 7 15 18 5 21
26
2520
13 12 11 14 17 6 23 24 2219
In CD mode, Press to change play mode cyclically as shown below.
3. NOMENCLATURE AND FUNCTIONS
[Front]
REPEAT TRACK REPEAT FOLDER
PLAY ALL REPEAT ALLPLAY ALL RANDOM
REPEAT TRACK
PLAY ALL
REPEAT ALL
PLAY ALL RANDOM
1. Power switch : Press ON to switch on the power. Press OFF to switch off the power.
2. USB Connector : Insert the USB.
3. LCD Display : CD status including track number and playing time.
4. Disc Drive : Insert the disc.
5. SD/MMC CARD Connector : Accept SD Card or MMC Card.
6. CD/USB/SD : Press this key to change to CD, USB or SD mode.
7. PLAY/PAUSE : Press once to start playing, press again to pause.
8. STOP : Press this key to stop playing.
9. CUE : Press this key to next track number.
10. REV : Press this key to previous track number.
11. FOLDER : Press to next folder. Available for USB and SD Card.
12. FOLDER : Press to previous folder. Available for USB and SD Card.
13. REPEAT : In MP3 mode and in USB mode, Press to change play mode cyclically as shown below.
14. A-B : When this key is pressed during play, the beginning is marked. Press this key one more time, the
end is also marked, and the set will play from the beginning to the end cyclically. Press this key again to
reset the function.
15. EJECT : Press this key to remove the disc.
16. PROG : Set to programming mode. When the STOP key is pressed during programming mode, all
programs are cleared.
17. MUTE : In playing mode, press this key to mute, press again to recovery.
18. CD Indicator : Press once CD/TUNER on remote controller to CD mode. The LED will light up.
19. FM TUNER Display : FM Tuner status including FM band and channels memory.
20. UP : Every time the UP key is pressed, the reception frequency is increased by 50kHz or 100kHz for FM.
(Depending on sales area, it has been adjusted to one of two.) When this key is pressed over 1.5
seconds, the auto tuning starts and stop automatically as soon as station is detected.
21. DOWN : Every time the DOWN key is pressed, the reception frequency is decreased by 50kHz or 100kHz
for FM. (Depending on sales area, it has been adjusted to one of two.) When this key is pressed over 1.5
seconds, the auto tuning starts and stop automatically as soon as station is detected.
22. MEMORY : This key can save preset memory. The FM band has fixed preset memory of 30 CH. To save
the displayed reception frequency in the preset memory, press the MEMORY key, then press the number
key. Press the MEMORY key again to save the reception frequency in that number key.
23. 1~10 : Press these keys to select preset station 1~10.
24. +10/- - : Press this key once and the preset station number will add 10. Press this key for more than 1.5
seconds, then use number key to input the preset station.
25. TUNER Indicator : Press once CD/TUNER on remote controller to TUNER mode. The LED will light up.
26. IR : Pick up signal from the remote controller.
1
2
16
12
11
10
9
13
19
4
3
5
8
6
15
14
17
18
7
28 29 30 31 32
[Rear]
[Remote Handset]
90 80 70 60 50 40 30 20 10
OFF
28. ANTENNA terminals : Connect to FM antenna. (75 Ohms)
29. TUNER OUT stereo terminals : Provide stereo audio output of received radio program. (RCA jack)
30. PRIORITY OUT stereo terminals : Provide stereo audio output in the following priority : CD, USB, SD, FM.
(RCA Jack)
31. CD OUT stereo terminals : Provide stereo audio output of CD program. (RCA jack)
32. AC Inlet : Connect to AC cord 220 - 240V.
1. PLAY/PAUSE : See No.7 on player unit.
2. STOP : See No.8 on player unit.
3. PROG/MEM : In CD mode, See No.16 on player unit. In TUNER mode,
See No.22 on player unit.
4. ID3/ASM : In CD mode, When this key is pressed, the ID3 in the LCD
display will flash, and the ID3 TAG is displayed, pressing this key again to
cancel the ID3 function. In TUNER mode, This is Auto scan mode and
memory function. Press this key for more than 1.5 seconds, the tuner will
search the station and store in memory automatically.
5. ESP-MO/ST : In CD mode, ESP is displayed in the LCD when the key is
pressed, and the electronic anti-shock is activated. The electronic
anti-shock time is about 40 seconds. In TUNER mode, Press this key, to
change between stereo and mono mode.
6. DIRECT : In TUNER mode, This is a direct search function. Press this key once, then use number key to
input the station frequency, press DIRECT key again to confirm the frequency. The tuner jump to this
station. If the input frequency is beyond the range, the tuner will display ERR.
7. 0-9; 1-10 : In CD mode, Use this key to select the track you want directly. In TUNER mode, See No.23
on the player unit.
8. +10/- - : In TUNER mode, See No.24 on player unit.
9. FOLDER/M-UP : In CD mode, See No.11 on player unit. In TUNER mode, Press this key to select preset
memory in increment.
10. FOLDER/M-DOWN : In CD mode, See No.12 on player unit. In TUNER mode, Press this key to select
preset memory in decrement.
11. UP/CUE : In CD mode, See No.9 on player unit. In TUNER mode, See No.20 on player unit.
12. DOWN/REV : In CD mode, See No.10 on player unit. In TUNER mode, See No.21 on player unit.
13. REPEAT : In CD mode, See No.13 on player unit.
14. A-B : In CD mode, See No.14 on player unit.
15. SLEEP : In TUNER mode, When SLEEP key is pressed, the sleep function is set and the sleep time in
display will flash for 5 seconds. The sleep time begins from 90 minutes and changes cyclically as shown
below. When the SLEEP function is set, the power is automatically switched off after the sleep time.
The sleep function is cleared, if the SLEEP key is pressed till the sleep time is not displayed on the LCD.
16. CD/USB/SD : In CD mode, See No.6 on player unit.
17. EJECT : In CD mode, See No.15 on player unit.
18. MUTE : In CD mode, See No.17 on player unit.
19. CD/TUNER : Switch between CD and TUNER for remote control.
27. Removable Mounting Brackets : For mounted on an EIA equipment rack
27
27
