Toshiba Bluetooth 2.0+EDR USB 2.0 Dongle User manual

Quick Installation Guide
Bluetooth 2.0+EDR
Class 2/Class 1 USB 2.0 Dongle

Thank you for purchasing the Bluetooth v2.0 +EDR Dongle. We hope you will enjoy the most
advanced Bluetooth technology with it. The package includes a Bluetooth V2.0+EDR Dongle,
which provides users a full range of Bluetooth features with computer devices. Please read the
user manual to make the best use of Bluetooth v2.0 +EDR Dongle and its many features.
■Package Contents
◆Bluetooth 2.0+EDR USB 2.0 Dongle
◆Quick Installation Guide
◆CD-ROM (User Manual/Driver/Utility)
Note
• The Bluetooth Utility operates under Windows XP and Windows 2000.
The descriptions in the examples mainly pertain to operation under Windows XP.
Windows XP: MicrosoftR WindowsR XP Operating System
Windows 2000: MicrosoftR WindowsR 2000 Operating System
Warning: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
The users manual or instruction manual for an intentional or unintentional radiator shall caution
the user that changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.

Software Installation
Note: Make sure the Bluetooth USB Adapter is unplugged. To install the software, please follow the
instruction below.
1. Insert the Toshiba Bluetooth driver installation CD into the CD-ROM. The “InstallShield Wizard”
should start automatically. If it does not load, please run the “Setup.exe” file from the CD drive.
2. A setup window will pop up. Please choice language to start installation process.
Note: The initial window varies depending on the version of driver you are installing.

3. The Welcome window should now appear, Click “Next”.
4. Accept the terms in the license agreement thend click “Next”.

5. Click “Install” to begin the installation.
6. Installation is in process.

7. Wait for the setup.
8. Plug in the EDR USB adapter and click “OK” to continue the installation.
9. Click “Finish” when the installation is completed.

10. Users will be asked to restart the system. Click “Yes” to restart the computer immediately.