TourGuide Solutions TGS-900 User manual

TGS-900 Tour Guide System
Thank you for choosing TourGuide Solutions! This Quick Start Guide and checklist will help you prepare
for your event. For complete setup details, reference your Operations Guide included with your purchase.
QUICK START GUIDE
Charging Your System
Batteries must be charged for a complete 2-hr cycle before first use.
Remove the drop-in charging tray from the carrying case. It is
located at the very bottom under the Velcro shelf.
Remove the AC/DC adapter from the right-hand pocket. Plug the
adapter into the charging tray and then into the wall port.
Receivers will already be inserted into the charging tray when
you receive your system.
Insert the transmitter into the charging tray. It is located in the
left-hand pocket of the carrying case.
Charge for a full 2 hours before first use.
Units are fully charged when the red LED turns off.
Transmitter Setup –Guide Equipment
A standard system will include 1 Transmitter and 1 Headset Microphone
Find the headset microphone in the front pocket of the carrying case.
Plug the headset microphone into the mic jack on top of the transmitter.
Receiver Setup –Guest Equipment
Each guest will be assigned 1 Receiver and 1 Stereo Headphone
Find the stereo headphones in the carrying case.
Plug the stereo headphones into the headphone jack of the receivers.
Quick Tip: The transmitter and receivers look very similar. To tell them
apart, check the label on the front of the devices. The transmitter is the
device with the black antenna.
www.tourguidesolutions.com [phone]

TGS-900 Tour Guide System
QUICK START GUIDE
Matching Transmitter and Receiver Channels
Turn on the transmitter and receiver using the side switch.
The screen will display volume level and then the channel
number. Both devices will automatically be set to Channel 01.
Confirm that the channel number on the guide’s transmitter
matches the channel number on the guests’ receivers.
Quick Tip: See page 8 in the Operations Guide to change channels.
www.tourguidesolutions.com [phone]
Now you’re ready to lead a successful tour!
If you have questions along the way, please contact us at
[e-mail] or [phone].
Setting Individual Volume
The factory volume level is set to 5 for the transmitter. It
is highly unlikely that you will need to adjust the
transmitter’s volume.
Receiver Volume: Turn the power to on position.
Use the –and + buttons to adjust the volume level.
Battery Life
TGS-900 transmitters and receivers include built-in
rechargeable lithium-ion batteries.
After completing the full 2-hour charge cycle, the
transmitter delivers up to 16 hours of operation and
the receivers deliver up to 25 hours of operation.
Adjusting
Receiver
Volume
Planning to Have Multiple Tours?
With the purchase of additional transmitters,
you can host multiple tours and add up to 25
guides for simultaneous tours.
Contact us for additional equipment.
When powering on
the transmitter, avoid
pressing other
buttons at the same
time. This could
trigger unwanted
changes in settings.
Important Tip!