TriangleTube instinct FSB SOLO 110-155-199 User manual

IoT WiFi Module
Installation Guide
SOLO 110-155-199 & COMBI 155-199
227638 A01
March 2021
2021-15 -
Instinct WiFi
Module
Guide
THE
ORIGINAL
INNO VA T ORS

LOCATION GUIDELINES
The IoT Module connects to the home
Wi-Fi network through a Wi-Fi chip.
The home Wi-Fi router should be
positioned no more than 30 metres
from the IoT module. Where possible
avoid directing Wi-Fi communication
through metal frames or solid concrete
walls.
REQUIREMENT CHECKLIST BEFORE FITTING THE IOT MODULE.
Before pairing the US device ensure you have completed the following:
• Supplied the email address registered to your Apple / Android Account to Mark Avron
• Download the Triangle Tube App.
Triangle Tube
• Completed the Registration process on the App.
• Obtained the Customers Home WIFI Network Name (SSID)
• Obtained the Customers WIFI Password
INSTALLATION STEPS
1. Locate the IoT WiFi module in the boiler
IoT Wi Fi Module overview
Power LED Bluetooth LED Connectivity LED
Pair Button
2
Power
Reset

Power
Power
2. Connecting the IoT WiFi module to the
customers Wi-Fi
a) Power on the boiler
Ensure the Power LED is solid GREEN and
Blue tooth blue LED is flashing blue.
b) Launch the mobile app
Triangle Tube
c) Follow the on-screen instructions to start
the device registration.
d) Once registration has completed ensure
the LED status is shown as below.
Note: If you do not see the blue Bluetooth LED as
shown here this just means your mobile phone has
disconnected from the IoT module. This is OK.
3
LED KEY:
Power LED
o Solid green - power to the
module
o No illumination – no power to
module
Bluetooth LED
o Flashing blue –
Bluetooth/Wi-Fi on
boarding mode
o Solid blue – Bluetooth
connection to
mobile device
Wi-Fi LED
o Flashing green indicates
searching/
identifying WIFI network
o Solid Blue LED indicates
successful
connection to the WIFI
network
o Solid Green LED indicates the
module has successfully
connected to the
Cloud
o Solid Red LED indicates failed
connection to WIFI
Power

TROUBLESHOOTING
• Bluetooth/Wi-Fi onboarding mode – After 2 minutes the Bluetooth will timeout (Blue Bluetooth LED
turns off) press and hold the pairing button for 5 seconds to re-enter Bluetooth/Wi-Fi onboarding pairing.
• Resetting the IOT module, press and hold the pairing button for 15 seconds - this resets the module to
factory settings (all LEDs will turn off and the device will reboot)
Colour Power LED Connectivity LED Bluetooth LED
Red Solid: Failed to connect to Wi-Fi
Green
Solid: Power On
Off: Power Off
Flashing: Locating WiFi
Solid: Connected to Cloud
Blue
Solid: Connectivity via WiFi (not
connected to cloud)
Flashing: Establishing WiFi
Flashing : Pairing service active, not
tethered
Solid : Bluetooth tehtered
Orange Solid: Factory reset in progress
Triangle Tube - 1240 Forest Parkway, Suite 100, West Deptford NJ 08066
Tel: [phone] - Fax: [phone] - E-mail: [e-mail]