TruVision TVD-CB5A User manual

P/N 1073446-EN • REV C • ISS 28JUL21 1 / 2
TVD-CB5A Cup Base Installation
Instructions
Specifications
Dimensions:
Weight: 382 g (13.47 oz.)
Accessories:
Rubber ring: 1 pcs
Used to prevent moisture from entering between the dome
camera and the cup base.
Supported devices:
•TVD-5404
•TVD-5405
•TVD-5406
•TVD-5407
•TVD-5408
Installing a TVD-CB5A cup
base to a dome camera
When assembling a TVD-CB5A cup base to a
dome camera, you require:
•TVD-CB5A cup base
•Rubber ring
Note: You will need to remove the dome
back box from the dome camera. It is not
required when installing in a cup base.
To mount a TVD-CB5A cup base to a
dome camera:
1. Screw the cup base onto the swan
neck or pendant mount and fasten
with the locking screw (pendant
mount shown as an example below).
2. Remove the back box from the
dome camera. It is not required
when installing in a cup base.

2 / 2 P/N 1073446-EN • REV C • ISS 28JUL21
3. Make sure that the rubber ring is
firmly in place between the cup base
and the dome housing.
4. Using the screws that are provided
with the dome, install the dome
assembly to the cup base.
5. Refer to the TruVision swan neck or
pendant mount installation manual
for instructions on installing a mount
to the dome camera (swan neck
assembly shown).
Legal and regulatory
information
Copyright
© 2021 Carrier. All rights reserved.
Specifications subject to change without prior
notice.
Trademarks and patents
TruVision names and logos are a product
brand of Aritech, a part of Carrier. Other trade
names used in this document may be
trademarks or registered trademarks of the
manufacturers or vendors of the respective
products.
Certification
Contact information
EMEA: https://firesecurityproducts.com
Australian/New Zealand:
https://firesecurityproducts.com.au/
Product documentation
Please consult the following web link to
retrieve the electronic version of the product
documentation. The manuals are available in
several languages.