U.S.T.E. VISTA DL-2237 User manual

INSTALLATION INSTRUCTIONS FOR 12 VOLT SPECIALTY LIGHTS
MODEL #DL-2237/ #DS-2237
FOR USE ONLY WITH LOW VOLTAGE LANDSCAPE POWER UNITS THAT DO NOT
EXCEED 25 AMPS, 15 VOLT MAX.
W
ARNING: Luminaires must be installed in accordance with the National Electrical
Code (NEC) and local codes. Failure to do so will void the warranty and may result in
serious injury and/or damage to the luminaire.
SAFETY WARNING: Luminaire can become very hot depending on lamp wattage used.
Lens and metal around lamp can become hot enough to blister hands. Particular care
should be taken not to locate luminaires where small children can reach them if high
wattage lamps are used.
LUMINAIRES ARE NOT TO BE INSTALLED WITHIN 10 FT. (3.05M) OF A
POOL OR SPA. SECONDARY CABLE IS NOT TO BE BURIED MORE THAN
6". WHEN USING MULTIPLE LUMINAIRES, LOAD IS NOT TO EXCEED
TOTAL WATTS OF TRANSFORMER RATING. DO NOT USE EXTENSION
CORDS ON POWER UNITS.
NOTE: Always use UL recognized wire connectors for connections.
NOTE: Save these instructions for future reference.
TOOLS REQUIRED FOR INSTALLATION:
Phillips head screwdriver Wire strippers
Mounting Holes
Shroud Screw Lens
Lens
Mounting Holes

1. To prevent electrical shock, disconnect transformer from electrical supply before installation or service.
2. Using the wiring compartment J-Box as a template, mark mounting hole position.
3. Strip the wire leads from the main supply cable. Connect main supply cable to luminaire
leads using silicone filled safety connectors (provided).
NOTE: Connections may be made remotely or inside J-Box wiring compartment.
4. Use appropriate screws (by others) to fasten to mounting surface.
NOTE: Luminaires are supplied with 60" of 18-2 cable pigtail for secure connection to the main
supply cable. The wire is to be protected by routing in close proximity to the luminaire.
The wiring shall be buried a maximum of 6 inches (15.2 cm) in order to connect to the
main supply cable.
5. Provide power to luminaire and check for proper operation.
IMPORTANT SAFETY INSTRUCTIONS
LIGHTED LAMP IS HOT!!
W
ARNING: TO REDUCE THE RISK OF FIRE, OR INJURY TO
PERSONS:
1. Turn off/unplug and allow to cool before replacing lamp.
2. Lamps get hot quickly! Contact only switch/plug when turning on.
3. Do not touch hot lens, guard or enclosure.
4. Keep lamp away from material that may burn.
5. Do not operate luminaire fitting with a missing or damaged cover.
LAMP INSTALLATION/REPLACEMENT:
CAUTION: Do not exceed maximum wattage marked on luminaire label.
1. To prevent electrical shock, disconnect transformer from electrical supply before service.
2. Loosen screw from shroud.
NOTE: Long shroud uses a phillips head screw to fasten shroud. Short shroud uses an
allen screw (allen wrench provided). Please save allen wrench for future use.
3. Remove shroud to expose lamp.
4. Replace lamp with correct wattage and type marked on fixture label.
5. Re-install shroud and tighten screw.
VISTAPROFESSIONALOUTDOORLIGHTING DivisionofU.S.T.E.Inc. Website:www.vistapro.com
1625SurveyorAvenue,SimiValley,CA93063 [phone] FAX:[phone] (800)766-847
8