UPC 3535 User manual

ASSEMBLY INSTRUCTIONS
Revised 01/27/15 Page 1 of 2
PARTS LIST
PARTS BAG UPC 3535 5.5” up to 48” wide with
2/3 Exposure 2-Tier PETG Rack
TOOLS REQUIRED: Flathead Screwdriver (Slatwall)
Drill with 3/8” Drywall Bit & Phillips Screwdriver (Drywall)
C
C
C
C
A
E
C
G
C
PART Quantity Reference
Screw Post 2-3 A
Slatwall Adapters 2-3 B
Nuts 2-3 C
Plastic Wall Toggler 2-3 D
Philips Head Screws 2-3 E
Card Clips 2-16 F
D
PART Quantity Reference
Rack 1G
B
B
B
B
B
Slatwall Assembly
Insert Card Clips (F) into
Rack (G).
NOTE: Assemble for EITHER Slatwall or Drywall, not both.
NOTE: Quantities of parts vary with width of
Rack chosen.
OR
5.5” up to 48”
(wide)
1
2
G
Align hole in Slatwall Adapter (B) with back side of hole in Rack (G).
Prongs extend back toward Slatwall and up. Attach using Screw Post (A)
from front and Nut (C) on back.
F
B
A
A
A
A
G
F
A
F

Page 2 of 2
D
D
D
D
D
Drywall Assembly
WALLWALL
WALLWALL
D
E
G
D
NOTE: Assemble for EITHER Slatwall or Drywall, not both.
OR
Insert Card Clips (F) into
Rack (G).
1Determine position on wall and drill hole
with 3/8” drywall bit. Squeeze Wall
Toggler (D) flat and insert into hole.
Tap flange flush with wall.
Place Rack (G) against
Wall Toggler (D) and insert
Phillips Head Screw (E),
tightening until secure.
3
2
G
E
E
G
E
E
E
G
E
E
G
E
E
E
F
F