UPC #0942 2-Tier 36" Break Resistant PETG Card Rack
ASSEMBLY INSTRUCTIONS
Revised 06/06/14 Page 1 of 2
PARTS LIST
ASSEMBLY
G
G
A
E
C
F
F
PART Quantity Reference
Screw Post 3A
Slatwall Adapters 3B
#8 - 32 Hex Nuts 3C
Plastic Wall Toggler 3D
Philips Head Screws 3E
D
PARTS BAG
PART Quantity Reference
Rack 1F
Divider 5 G
TOOLS REQUIRED: Phillips & Flathead Screwdriver
& Drill with 3/8” Drywall Bit
B
B
B
A
A
C
C
A
B
C
Align hole in Slatwall Adapters (B) with
back side of hole in Rack (F). Prongs extend
back toward Slatwall and up. Attach using
Screw Post (A) from front and Nut (C)
on back.
Slatwall Assembly
1
Insert Divider (G) into
Rack (F).
NOTE: Assemble for EITHER Slatwall or Drywall, not both.
2
