5 | Page
●Use the M8 tie rods as guidance, place the
mounting brackets, and secure the brackets with
provided washers and nuts. Cut the bolt to desired
length if needed.
DO NOT OVERTIGHTEN!
4.5 Connect Wiring
●Connect the unit to the power cable. On this
end, the cable should have fuse boxes on both
positive and ground.
●On the other end of the power cable, connect
to the battery. On this end, there is only one fuse
box on positive.
4.6 Install the Decor Panel
●Use the provided self-tightening screws and
washers to secure the decor panel to the roof.
4. OPERATING INSTRUCTIONS
5.1 Control Panel
1 - Power ON/OFF: short press to turn on the unit.
Long press three seconds to turn off the unit. Long
press ten seconds to reset to factory default
setting.
2 - Mode Switch: short press to switch between
operating modes: Fan only, Turbo, Eco, Sleep
3 - Fan Speed +: Increase fan speed
4 - Fan Speed -: Decrease fan speed
5 - Temperature +: Increase setting temperature
6 - Temperature -: Decrease setting temperature
5.2 Edit Low Voltage Protection
Long press the Mode Switch to edit low voltage
protection. Press Fan Speed + to increase cut-off
voltage. Press Fan Speed - to decrease cut-off
voltage. Press Temperature + to increase recover
voltage. Press Temperature - to decrease recover
voltage.
5. MAINTENANCE
6.1 Under/over-voltage protection
Low voltage protection will auto shut off the unit
when the supplied voltage is lower than the cut-off
voltage (default 10.5V) and the low-voltage red
light will light up. The unit will turn on
automatically once the supplied voltage is higher
than the recover voltage (default 12V).
When the supplied voltage is higher than 18V, the
unit will turn off and the high-voltage red light will
light up. The unit will turn on automatically once
the supplied voltage is lower than 18V.
6.2 Error code
There are multiple sensors built inside the unit.
When an error is detected, the error icon will flash
