Vent VK PS Series User manual

www.vents-us.com
User’s
manual
EN
INLINE CENTRIFUGAL FANS
VENTS VKPS SERIES

2
READ CAREFULLY AND SAVE THESE INSTRUCTIONS
EN
WARNING!
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK AND PERSONAL INJURY, READ AND
UNDERSTAND THE INSTRUCTIONS CAREFULLY
1. Use the product only in the manner intended by the manufacturer. If you have questions, contact the
manufacturer.
2. Before servicing or cleaning the unit, switch off the power at the main service panel and lock it to
prevent the power from being accidentally turned on. If the panel cannot be locked securely, fasten a
prominent warning device, such as tag, to it. If the unit is not hard-wired but rather plugged into a
120 volt outlet, simply unplug the cord from the receptacle.
3. Installation work and electrical wiring must be done by qualified person(s) in accordance with all
applicable codes and standards, include fire-rated construction codes and standards.
4. When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.
5. The fans must always be vented to the outdoors.
6. The fan may have sharp edges. Use caution to avoid being cut when installing and cleaning.
7. This fan must be grounded.
CAUTION!
1. For general ventilation use only. Not for use in fire rated installations.
Do not use the fan to exhaust hazardous or explosive materials and vapors.
2. For interior use only. Mount the fan with the lowest moving parts at least 8 feet (2.5 meters) above the
floor or grade level.
3. To avoid the motor damage and noisy and/or unbalanced impeller, keep drywall spray, construction
dust, etc. off the power unit.
4. Prior to installation operations make sure there is no visible damage to the impeller and housing.
Also make sure there are no foreign objects that may have accidentally gotten into the fan.
5. Please read specification label on product for further information and requirements.
6. To be installed by qualified personnel.
7. Connect the fan through the breaker box.
8. Both the inlet and outlet must have no obstructions for the fan to work properly and be covered by the
warranty.
9. When storing the fan keep it in a dry, weather-protected environment in the original packaging.
If the fan has been stored or set in a cold environment, wait 2 hours before connecting it to the power
source.

3
VK PS fan is designed for installation into a ductwork of a
clothes dryer and pressure boosting in the exhaust air duct
to increase the clothes dryer operating efficiency. The
integrated differential pressure switch controls the turning
on/off operations. VK PS turning on/off cycles are
synchronized with the turning on/off cycles of the fan in the
clothes dryer.
Box includes:
1. Fan - 1
2 - 4. Screws and countersinks
3 - 1. User's manual
The fans are compatible with 4” (100 mm), 5” (125 mm), 6”
(150 mm) diameter ducts.
Understanding the Model Numbers:
The three digit number in all model names indicates the
following:
100 (100 mm) means it is used with 4” duct
125 (125 mm) means it is used with 5” duct
150 (150 mm) means it is used with 6” duct
Equipped with a power cord and a plug for connection to a
standard wall power socket or with a terminal box for direct
connection to power.
The outlet end should always be connected to a duct.
Mounting is shown in Fig. . 2
The direction of the air must match the direction of the
arrow on the housing.
Input: 120 V AC 60 Hz. Connection to the power source is
shown in Fig. .10
The fan is designed for continuous operation.
Protection rating from access of dangerous parts and
water penetration is IPX4.
The fan can be operated at ambient temperatures between
+32 °F and +149 ° F.
The fans are suitable for vertical or horizontal mounting.
To ensure correct operation of the automation install the
differential pressure switch vertically, see Fig. 3.
Remove dust and dirt from the unit surface every 6
months (Fig. 11-18). Disconnect the unit from power
mains prior to any maintenance operations. Clean the
fan with a soft cloth and a brush using a water-diluted
neutral detergent. Protect the electric parts of the fan
against ingress of water. After cleaning wipe the
product's surface dry.

WARRANTY
Production meets standard operating requirements in the
USA and Canada.
VENTS US warrants to the original purchaser of the VKPS
series fan that it will be free from defects in materials or
workmanship for a period of 24 months from the date
of original purchase.
4
THERE ARE NO OTHER WARRANTIES, EXPRESS OR
IMPLIED, INCLUDING, BUT NOT LIMITED TO, IMPLIED
WARRANTIES OF MERCHANTABILITY OR FITNESS
FOR A PARTICULAR PURPOSE.
During the stated warranty period, VENTS US will, at its option,
repair or replace, without charge, any product or part which
is found to be defective under normal use and service.
This warranty does not cover (a) normal maintenance and
normal service or (b) any products or parts which have been
subject to misuse, negligence, accident, improper
maintenance or repair (other than by VENTS US), faulty
installation or installation contrary to recommended
installation instructions. Labor to remove and replace
products is not covered. The duration of any implied warranty
is limited to the time period specified for the express warranty.
Some states do not allow limitations on how long an implied
warranty lasts, so the above limitation may not apply to you.
VENTS US OBLIGATION TO REPAIR OR REPLACE, AT
VENTS US OPTION, SHALL BE THE PURCHASER'S SOLE
AND EXCLUSIVE REMEDY UNDER THIS WARRANTY.
VENTS US SHALL NOT BE LIABLE FOR INCIDENTAL,
CONSEQUENTIAL OR SPECIAL DAMAGES ARISING OUT
OF OR IN CONNECTION WITH PRODUCT USE OR
PERFORMANCE.
Some states do not allow the exclusion or limitations of
incidental or consequential damages, so the above limitation
or exclusion may not apply to you. This warranty gives you
specific legal rights, and you may also have other rights which
vary from state to state. This warranty supersedes all prior
warranties.
If proof of sales date is absent, warranty period is calculated
from the production date.
The unit can be exchanged at the following
address: Bodor Vents, LLC
400 Murray Road, Cincinnati, Ohio 45217
Phone: [phone]
e-mail: [email protected]
Please follow guidelines in this manual for product
problem-free operation.
Fan construction is constantly being improved, that is why
some models can differ slightly from those described in this
manual models.

Size ranges
Model Dimensions [in]
Weight
[lbs]
ØDØD1 B B1 L L1 L2 L3
VK 100 PS 3 / 9 / 10 / 13 / 9 / 1 / 1 / 1 / 4.7
VK 125 PS 4 / 9 / 10 / 13 / 8 / 1 / 1 / 1 / 4.9
VK 150 PS 5 / 11 / 12 / 15 / 11 / 1 / 1 / 1 / 5.7
VK PS
Вентилятор VK PS предназначен для установки в воздуховод вентиляционной системы сушильной машины и
усиления напора воздуха в вытяжном канале с целью увеличения эффективности работы сушильной маши-
ны. Вентилятор оборудован прессостатом для автоматического включения и выключения. Вентилятор вклю-
чается и выключается одновременно с вентилятором сушильной машины.
Для увеличения срока службы и пе-
риода технического обслуживания
вентилятора рекомендуется устано-
вить улавливатель ворса между су-
шильной машиной и вентилятором
VK PS и переодически его очищать.
Lint Trap
VK PS
Size ranges
Model Dimensions [in]
Weight
[lbs]
ØDØD1 B B1 L L1 L2 L3
VK PS 100 3 / 9 / 10 / 13 / 9 / 1 / 1 / 1 / 4.7
VK PS 125 4 / 9 / 10 / 13 / 8 / 1 / 1 / 1 / 4.9
VK PS 150 5 / 11 / 12 / 15 / 11 / 1 / 1 / 1 / 5.7
VK PS
Lint Trap
VK PS
5
12
Install a lint trap between the clothes dryer and
the fan to increase the service life and
maintenance periodicity of VK PS. Clean the
lint trap as required.

INSTALLATIONTYPICAL
3
6

7
INSTALLATION OF THE FAN
6
5
4
78 9
QF

10
120 VAC, 60 Hz
BREAKER
GREEN
GROUND
SCREW
BREAKER BOX
EARTH
FAN
WALL SOCKET
CONNECTION OF THE FAN
8

11 12 13
14 16
17 18
15
QF
Fan cleaning
9

10

11

www.vents-us.com
100
125
150
VK PS
ACCEPTANCE CERTIFICATE
Date of sale
V121EN-01(USA_120)
Manufactured on (date):
Approval mark
Sold by
(n )ame of trading enterprise, stamp of store
The fan has been duly certified as serviceable.